1 =============================================================================
\r
2 List of methods in project: RTOSDemo
\r
4 THIS TEXT DESCRIPTION IS GENERATED BY THE TOOL. DO NOT MODIFY IT.
\r
5 =============================================================================
\r
7 Module "TickTimer" (bean TimerInt)
\r
8 TickTimer_Enable -Enable the bean - it starts the timer. Events may be generated ("DisableEvent"/"EnableEvent").
\r
9 TickTimer_SetPeriodTicks16 -This method sets the new period of the generated events. The period is expressed in CPU [ticks]
\r
10 as a 16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is
\r
11 selected in the <Timing dialog box> in Runtime setting area.
\r
12 TickTimer_SetPeriodTicks32 -This method sets the new period of the generated events. The period is expressed in CPU [ticks]
\r
13 as a 32-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is
\r
14 selected in the <Timing dialog box> in Runtime setting area.
\r
15 TickTimer_SetPeriodUS -This method sets the new period of the generated events. The period is expressed in [microseconds] as
\r
16 a 16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is
\r
17 selected in the <Timing dialog box> in Runtime setting area.
\r
18 TickTimer_SetPeriodMS -This method sets the new period of the generated events. The period is expressed in [miliseconds] as
\r
19 a 16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is
\r
20 selected in the <Timing dialog box> in Runtime setting area.
\r
21 TickTimer_SetFreqHz -This method sets the new frequency of the generated events. The frequency is expressed in [Hz] as a
\r
22 16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is
\r
23 selected in the <Timing dialog box> in Runtime setting area.
\r
25 Module "Byte1" (bean ByteIO)
\r
26 Byte1_PutBit -Put the specified value to the specified bit/pin of the Input/Output bean. If direction is [input] saves the
\r
27 value to a memory or a register, this value will be written to the pin after switching to the output mode -
\r
28 using [SetDir(TRUE)]. If direction is [output] writes the value to the pin.
\r
29 Byte1_NegBit -Negate (invert) the specified bit of the Input/Output bean. It is the same as [PutBit(Bit,!GetBit(Bit))].
\r
31 Module "COM0" (bean AsynchroSerial)
\r
32 COM0_SetBaudRateMode -This method changes the channel communication speed (baud rate). This method can be used only if you
\r
33 specify a list of possible period settings at design time (see <Timing dialog box> - Runtime setting - from a
\r
34 list of values). Each of these settings constitutes a mode and Processor Expert^[TM] assigns them a mode
\r
35 identifier. The prescaler and compare values corresponding to each mode are calculated at design time. You may
\r
36 switch modes at runtime by referring only to a mode identifier. No run-time calculations are performed, all the
\r
37 calculations are performed at design time.
\r
39 Module "Cpu" (bean MC9S12DP256_112)
\r
40 Cpu_EnableInt -Enable maskable interrupts
\r
41 Cpu_DisableInt -Disable maskable interrupts
\r
43 =============================================================================
\r