7 select SYS_FSL_ERRATUM_A010315
8 select ARCH_EARLY_INIT_R
9 select BOARD_EARLY_INIT_F
13 select ARMV8_SET_SMPEN
17 select SYS_FSL_DDR_VER_50
18 select SYS_FSL_ERRATUM_A008850
19 select SYS_FSL_ERRATUM_A009660
20 select SYS_FSL_ERRATUM_A009663
21 select SYS_FSL_ERRATUM_A009929
22 select SYS_FSL_ERRATUM_A009942
23 select SYS_FSL_ERRATUM_A010315
24 select SYS_FSL_ERRATUM_A010539
25 select SYS_FSL_HAS_DDR3
26 select SYS_FSL_HAS_DDR4
27 select ARCH_EARLY_INIT_R
28 select BOARD_EARLY_INIT_F
32 select ARMV8_SET_SMPEN
36 select SYS_FSL_DDR_VER_50
37 select SYS_FSL_ERRATUM_A008336
38 select SYS_FSL_ERRATUM_A008511
39 select SYS_FSL_ERRATUM_A009801
40 select SYS_FSL_ERRATUM_A009803
41 select SYS_FSL_ERRATUM_A009942
42 select SYS_FSL_ERRATUM_A010165
43 select SYS_FSL_ERRATUM_A010539
44 select SYS_FSL_HAS_DDR4
46 select ARCH_EARLY_INIT_R
47 select BOARD_EARLY_INIT_F
51 select ARMV8_SET_SMPEN
52 select ARM_ERRATA_826974
53 select ARM_ERRATA_828024
54 select ARM_ERRATA_829520
55 select ARM_ERRATA_833471
59 select SYS_FSL_DDR_VER_50
60 select SYS_FSL_HAS_DP_DDR
61 select SYS_FSL_HAS_SEC
62 select SYS_FSL_HAS_DDR4
63 select SYS_FSL_SEC_COMPAT_5
66 select SYS_FSL_ERRATUM_A008336
67 select SYS_FSL_ERRATUM_A008511
68 select SYS_FSL_ERRATUM_A008514
69 select SYS_FSL_ERRATUM_A008585
70 select SYS_FSL_ERRATUM_A009635
71 select SYS_FSL_ERRATUM_A009663
72 select SYS_FSL_ERRATUM_A009801
73 select SYS_FSL_ERRATUM_A009803
74 select SYS_FSL_ERRATUM_A009942
75 select SYS_FSL_ERRATUM_A010165
76 select SYS_FSL_ERRATUM_A009203
77 select ARCH_EARLY_INIT_R
78 select BOARD_EARLY_INIT_F
82 select SYS_FSL_HAS_SEC
83 select SYS_FSL_SEC_COMPAT_5
94 bool "Management Complex network"
95 depends on ARCH_LS2080A
99 Enable Management Complex (MC) network
101 menu "Layerscape architecture"
102 depends on FSL_LSCH2 || FSL_LSCH3
104 config FSL_PCIE_COMPAT
105 string "PCIe compatible of Kernel DT"
106 depends on PCIE_LAYERSCAPE
107 default "fsl,ls1012a-pcie" if ARCH_LS1012A
108 default "fsl,ls1043a-pcie" if ARCH_LS1043A
109 default "fsl,ls1046a-pcie" if ARCH_LS1046A
110 default "fsl,ls2080a-pcie" if ARCH_LS2080A
112 This compatible is used to find pci controller node in Kernel DT
115 config HAS_FEATURE_GIC64K_ALIGN
117 default y if ARCH_LS1043A
119 config HAS_FEATURE_ENHANCED_MSI
121 default y if ARCH_LS1043A
123 menu "Layerscape PPA"
125 bool "FSL Layerscape PPA firmware support"
126 depends on !ARMV8_PSCI
127 select ARMV8_SEC_FIRMWARE_SUPPORT
128 select SEC_FIRMWARE_ARMV8_PSCI
129 select ARMV8_SEC_FIRMWARE_ERET_ADDR_REVERT if FSL_LSCH2
131 The FSL Primary Protected Application (PPA) is a software component
132 which is loaded during boot stage, and then remains resident in RAM
133 and runs in the TrustZone after boot.
136 prompt "FSL Layerscape PPA firmware loading-media select"
137 depends on FSL_LS_PPA
138 default SYS_LS_PPA_FW_IN_MMC if SD_BOOT
139 default SYS_LS_PPA_FW_IN_NAND if NAND_BOOT
140 default SYS_LS_PPA_FW_IN_XIP
142 config SYS_LS_PPA_FW_IN_XIP
145 Say Y here if the PPA firmware locate at XIP flash, such
146 as NOR or QSPI flash.
148 config SYS_LS_PPA_FW_IN_MMC
149 bool "eMMC or SD Card"
151 Say Y here if the PPA firmware locate at eMMC/SD card.
153 config SYS_LS_PPA_FW_IN_NAND
156 Say Y here if the PPA firmware locate at NAND flash.
160 config SYS_LS_PPA_FW_ADDR
161 hex "Address of PPA firmware loading from"
162 depends on FSL_LS_PPA
163 default 0x40500000 if SYS_LS_PPA_FW_IN_XIP && QSPI_BOOT
164 default 0x580a00000 if SYS_LS_PPA_FW_IN_XIP && ARCH_LS2080A
165 default 0x60500000 if SYS_LS_PPA_FW_IN_XIP
166 default 0x500000 if SYS_LS_PPA_FW_IN_MMC
167 default 0x500000 if SYS_LS_PPA_FW_IN_NAND
170 If the PPA firmware locate at XIP flash, such as NOR or
171 QSPI flash, this address is a directly memory-mapped.
172 If it is in a serial accessed flash, such as NAND and SD
173 card, it is a byte offset.
175 config SYS_LS_PPA_ESBC_ADDR
176 hex "hdr address of PPA firmware loading from"
177 depends on FSL_LS_PPA && CHAIN_OF_TRUST
178 default 0x600c0000 if SYS_LS_PPA_FW_IN_XIP && ARCH_LS1043A
179 default 0x580c40000 if SYS_LS_PPA_FW_IN_XIP && FSL_LSCH3
181 If the PPA header firmware locate at XIP flash, such as NOR or
182 QSPI flash, this address is a directly memory-mapped.
183 If it is in a serial accessed flash, such as NAND and SD
184 card, it is a byte offset.
188 config SYS_FSL_ERRATUM_A010315
189 bool "Workaround for PCIe erratum A010315"
191 config SYS_FSL_ERRATUM_A010539
192 bool "Workaround for PIN MUX erratum A010539"
195 int "Maximum number of CPUs permitted for Layerscape"
196 default 4 if ARCH_LS1043A
197 default 4 if ARCH_LS1046A
198 default 16 if ARCH_LS2080A
201 Set this number to the maximum number of possible CPUs in the SoC.
202 SoCs may have multiple clusters with each cluster may have multiple
203 ports. If some ports are reserved but higher ports are used for
204 cores, count the reserved ports. This will allocate enough memory
205 in spin table to properly handle all cores.
210 Enable Freescale Secure Boot feature
213 bool "Init the QSPI AHB bus"
215 The default setting for QSPI AHB bus just support 3bytes addressing.
216 But some QSPI flash size up to 64MBytes, so initialize the QSPI AHB
217 bus for those flashes to support the full QSPI flash size.
219 config SYS_FSL_IFC_BANK_COUNT
220 int "Maximum banks of Integrated flash controller"
221 depends on ARCH_LS1043A || ARCH_LS1046A || ARCH_LS2080A
222 default 4 if ARCH_LS1043A
223 default 4 if ARCH_LS1046A
224 default 8 if ARCH_LS2080A
226 config SYS_FSL_HAS_DP_DDR
229 config SYS_FSL_SRDS_1
232 config SYS_FSL_SRDS_2
235 config SYS_HAS_SERDES
240 menu "Layerscape clock tree configuration"
241 depends on FSL_LSCH2 || FSL_LSCH3
244 bool "Enable clock tree initialization"
247 config CLUSTER_CLK_FREQ
248 int "Reference clock of core cluster"
249 depends on ARCH_LS1012A
252 This number is the reference clock frequency of core PLL.
253 For most platforms, the core PLL and Platform PLL have the same
254 reference clock, but for some platforms, LS1012A for instance,
255 they are provided sepatately.
257 config SYS_FSL_PCLK_DIV
258 int "Platform clock divider"
259 default 1 if ARCH_LS1043A
260 default 1 if ARCH_LS1046A
263 This is the divider that is used to derive Platform clock from
264 Platform PLL, in another word:
265 Platform_clk = Platform_PLL_freq / this_divider
267 config SYS_FSL_DSPI_CLK_DIV
268 int "DSPI clock divider"
269 default 1 if ARCH_LS1043A
272 This is the divider that is used to derive DSPI clock from Platform
273 PLL, in another word DSPI_clk = Platform_PLL_freq / this_divider.
275 config SYS_FSL_DUART_CLK_DIV
276 int "DUART clock divider"
277 default 1 if ARCH_LS1043A
280 This is the divider that is used to derive DUART clock from Platform
281 clock, in another word DUART_clk = Platform_clk / this_divider.
283 config SYS_FSL_I2C_CLK_DIV
284 int "I2C clock divider"
285 default 1 if ARCH_LS1043A
288 This is the divider that is used to derive I2C clock from Platform
289 clock, in another word I2C_clk = Platform_clk / this_divider.
291 config SYS_FSL_IFC_CLK_DIV
292 int "IFC clock divider"
293 default 1 if ARCH_LS1043A
296 This is the divider that is used to derive IFC clock from Platform
297 clock, in another word IFC_clk = Platform_clk / this_divider.
299 config SYS_FSL_LPUART_CLK_DIV
300 int "LPUART clock divider"
301 default 1 if ARCH_LS1043A
304 This is the divider that is used to derive LPUART clock from Platform
305 clock, in another word LPUART_clk = Platform_clk / this_divider.
307 config SYS_FSL_SDHC_CLK_DIV
308 int "SDHC clock divider"
309 default 1 if ARCH_LS1043A
310 default 1 if ARCH_LS1012A
313 This is the divider that is used to derive SDHC clock from Platform
314 clock, in another word SDHC_clk = Platform_clk / this_divider.
320 Reserve memory from the top, tracked by gd->arch.resv_ram. This
321 reserved RAM can be used by special driver that resides in memory
322 after U-Boot exits. It's up to implementation to allocate and allow
323 access to this reserved memory. For example, the reserved RAM can
324 be at the high end of physical memory. The reserve RAM may be
325 excluded from memory bank(s) passed to OS, or marked as reserved.
327 config SYS_FSL_ERRATUM_A008336
330 config SYS_FSL_ERRATUM_A008514
333 config SYS_FSL_ERRATUM_A008585
336 config SYS_FSL_ERRATUM_A008850
339 config SYS_FSL_ERRATUM_A009203
342 config SYS_FSL_ERRATUM_A009635
345 config SYS_FSL_ERRATUM_A009660
348 config SYS_FSL_ERRATUM_A009929
351 config SYS_MC_RSV_MEM_ALIGN
352 hex "Management Complex reserved memory alignment"
356 Reserved memory needs to be aligned for MC to use. Default value