8 prompt "AM33xx board select"
11 config TARGET_AM335X_EVM
12 bool "Support am335x_evm"
13 select BOARD_LATE_INIT
17 select TI_I2C_BOARD_DETECT
19 This option specifies support for the AM335x
20 GP and HS EVM development platforms. The AM335x
21 GP EVM is a standalone test, development, and
22 evaluation module system that enables developers
23 to write software and develop hardware around
24 an AM335x processor subsystem.
26 config TARGET_AM335X_BALTOS
27 bool "Support am335x_baltos"
28 select BOARD_LATE_INIT
33 config TARGET_AM335X_IGEP0033
34 bool "Support am335x_igep0033"
39 config TARGET_AM335X_SHC
40 bool "Support am335x based shc board from bosch"
41 select BOARD_LATE_INIT
46 config TARGET_AM335X_SL50
47 bool "Support am335x_sl50"
48 select BOARD_LATE_INIT
54 bool "Support bav335x"
55 select BOARD_LATE_INIT
59 The BAV335x OEM Network Processor integrates all the functions of an
60 embedded network computer in a small, easy to use SODIMM module which
61 incorporates the popular Texas Instruments Sitara 32bit ARM Coretex-A8
62 processor, with fast DDR3 512MB SDRAM, 4GB of embedded MMC and a Gigabit
63 ethernet with simple connection to external connectors.
65 For more information, visit: http://birdland.com/oem
68 bool "Support cm_t335"
80 bool "Support pengwyn"
97 config SPL_EXT_SUPPORT
100 config SPL_GPIO_SUPPORT
103 config SPL_I2C_SUPPORT
106 config TARGET_AM43XX_EVM
107 bool "Support am43xx_evm"
108 select BOARD_LATE_INIT
109 select TI_I2C_BOARD_DETECT
111 This option specifies support for the AM43xx
112 GP and HS EVM development platforms.The AM437x
113 GP EVM is a standalone test, development, and
114 evaluation module system that enables developers
115 to write software and develop hardware around
116 an AM43xx processor subsystem.
120 config ISW_ENTRY_ADDR
121 hex "Address in memory or XIP flash of bootloader entry point"
123 After any reset, the boot ROM on the AM43XX SOC
124 searches the boot media for a valid boot image.
125 For non-XIP devices, the ROM then copies the
126 image into internal memory.
127 For all boot modes, after the ROM processes the
128 boot image it eventually computes the entry
129 point address depending on the device type
130 (secure/non-secure), boot media (xip/non-xip) and
132 default 0x402F4000 if AM43XX
133 default 0x402F0400 if AM33XX
135 config PUB_ROM_DATA_SIZE
136 hex "Size in bytes of the L3 SRAM reserved by ROM to store data"
138 During the device boot, the public ROM uses the top of
139 the public L3 OCMC RAM to store r/w data like stack,
140 heap, globals etc. When the ROM is copying the boot
141 image from the boot media into memory, the image must
142 not spill over into this area. This value can be used
143 during compile time to determine the maximum size of a
144 boot image. Once the ROM transfers control to the boot
145 image, this area is no longer used, and can be reclaimed
146 for run time use by the boot image.