3 bool "Bit-banged ethernet MII management channel support"
5 config MV88E6352_SWITCH
6 bool "Marvell 88E6352 switch support"
9 bool "Ethernet PHY (physical media interface) support"
11 Enable Ethernet PHY (physical media interface) support.
15 config MV88E61XX_SWITCH
16 bool "Marvel MV88E61xx Ethernet switch PHY support."
20 config MV88E61XX_CPU_PORT
23 config MV88E61XX_PHY_PORTS
24 hex "Bitmask of PHY Ports"
26 config MV88E61XX_FIXED_PORTS
27 hex "Bitmask of PHYless serdes Ports"
29 endif # MV88E61XX_SWITCH
32 bool "Generic 10G PHY support"
35 bool "Aquantia Ethernet PHYs support"
38 bool "Atheros Ethernet PHYs support"
41 bool "Broadcom Ethernet PHYs support"
44 bool "Cortina Ethernet PHYs support"
47 bool "Davicom Ethernet PHYs support"
50 bool "LSI TruePHY ET1011C support"
53 bool "LXT971 Ethernet PHY support"
56 bool "Marvell Ethernet PHYs support"
59 bool "Micrel Ethernet PHYs support"
61 config PHY_MICREL_KSZ9021
62 bool "Micrel KSZ9021 Ethernet PHYs support"
65 KSZ9021 is a completely integrated triple speed (10Base-T/100Base-TX/1000Base-T)
66 Ethernet Physical Layer Transceiver for transmission and reception of data over
67 standard CAT-5 unshielded twisted pair (UTP) cable.
70 bool "Microsemi Corp Ethernet PHYs support"
73 bool "National Semiconductor Ethernet PHYs support"
76 bool "Realtek Ethernet PHYs support"
78 config RTL8211X_PHY_FORCE_MASTER
79 bool "Ethernet PHY RTL8211x: force 1000BASE-T master mode"
80 depends on PHY_REALTEK
82 Force master mode for 1000BASE-T on RTl8211x PHYs (except for RTL8211F).
83 This can work around link stability and data corruption issues on gigabit
84 links which can occur in slave mode on certain PHYs, e.g. on the
87 Please note that two directly connected devices (i.e. via crossover cable)
88 will not be able to establish a link between each other if they both force
89 master mode. Multiple devices forcing master mode when connected by a
90 network switch do not pose a problem as the switch configures its affected
91 ports into slave mode.
93 This option only affects gigabit links. If you must establish a direct
94 connection between two devices which both force master mode, try forcing
95 the link speed to 100MBit/s.
100 bool "Microchip(SMSC) Ethernet PHYs support"
102 config PHY_TERANETICS
103 bool "Teranetics Ethernet PHYs support"
106 bool "Texas Instruments Ethernet PHYs support"
109 bool "Vitesse Ethernet PHYs support"
112 bool "Xilinx Ethernet PHYs support"
115 bool "Fixed-Link PHY"
118 Fixed PHY is used for having a 'fixed-link' to another MAC with a direct
119 connection (MII, RGMII, ...).
120 There is nothing like autoneogation and so
121 on, the link is always up with fixed speed and fixed duplex-setting.
122 More information: doc/device-tree-bindings/net/fixed-link.txt