2 * (C) Copyright 2005, Psyent Corporation <www.psyent.com>
3 * Scott McNutt <smcnutt@psyent.com>
4 * (C) Copyright 2010, Thomas Chou <thomas@wytron.com.tw>
6 * SPDX-License-Identifier: GPL-2.0+
15 #define CONFIG_DISPLAY_BOARDINFO_LATE
20 #define CONFIG_SYS_NS16550_MEM32
25 #define CONFIG_SYS_MAX_FLASH_BANKS 1
26 #define CONFIG_SYS_MAX_FLASH_SECT 1024
27 #define CONFIG_MTD_DEVICE
32 #define CONFIG_SYS_RX_ETH_BUFFER 0
33 #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
34 #define CONFIG_PHY_MARVELL
39 #define CONFIG_BOOTP_BOOTFILESIZE
48 * -Monitor at top of sdram.
49 * -The heap is placed below the monitor
50 * -The stack is placed below the heap (&grows down).
52 #define CONFIG_SYS_SDRAM_BASE 0xc8000000
53 #define CONFIG_SYS_SDRAM_SIZE 0x08000000
54 #define CONFIG_NR_DRAM_BANKS 1
55 #define CONFIG_MONITOR_IS_IN_RAM
56 #define CONFIG_SYS_MONITOR_LEN 0x80000 /* Reserve 512k */
57 #define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_SDRAM_BASE + \
58 CONFIG_SYS_SDRAM_SIZE - \
59 CONFIG_SYS_MONITOR_LEN)
60 #define CONFIG_SYS_MALLOC_LEN 0x20000
63 * ENVIRONMENT -- Put environment in sector CONFIG_SYS_MONITOR_LEN above
64 * CONFIG_SYS_RESET_ADDR, since we assume the monitor is stored at the
65 * reset address, no? This will keep the environment in user region
66 * of flash. NOTE: the monitor length must be multiple of sector size
67 * (which is common practice).
70 #define CONFIG_ENV_SIZE 0x10000 /* 64k, 1 sector */
71 #define CONFIG_ENV_OVERWRITE /* Serial change Ok */
72 #define CONFIG_ENV_ADDR (0xf4000000 + CONFIG_SYS_MONITOR_LEN)
77 #define CONFIG_SYS_LOAD_ADDR 0xcc000000 /* Half of RAM */
78 #define CONFIG_LOADADDR CONFIG_SYS_LOAD_ADDR
79 #define CONFIG_SYS_MEMTEST_START CONFIG_SYS_SDRAM_BASE
80 #define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_MONITOR_BASE - \
82 CONFIG_SYS_MALLOC_LEN - \
85 #endif /* __CONFIG_H */