1 /*****************************************************************************/
5 /* Environment independent low level optimizations */
9 /* (C) 2001 Ullrich von Bassewitz */
11 /* D-70597 Stuttgart */
12 /* EMail: uz@cc65.org */
15 /* This software is provided 'as-is', without any expressed or implied */
16 /* warranty. In no event will the authors be held liable for any damages */
17 /* arising from the use of this software. */
19 /* Permission is granted to anyone to use this software for any purpose, */
20 /* including commercial applications, and to alter it and redistribute it */
21 /* freely, subject to the following restrictions: */
23 /* 1. The origin of this software must not be misrepresented; you must not */
24 /* claim that you wrote the original software. If you use this software */
25 /* in a product, an acknowledgment in the product documentation would be */
26 /* appreciated but is not required. */
27 /* 2. Altered source versions must be plainly marked as such, and must not */
28 /* be misrepresented as being the original software. */
29 /* 3. This notice may not be removed or altered from any source */
32 /*****************************************************************************/
45 /*****************************************************************************/
47 /*****************************************************************************/
51 unsigned OptDeadJumps (CodeSeg* S);
52 /* Remove dead jumps (jumps to the next instruction) */
54 unsigned OptDeadCode (CodeSeg* S);
55 /* Remove dead code (code that follows an unconditional jump or an rts/rti
59 unsigned OptJumpCascades (CodeSeg* S);
60 /* Optimize jump cascades (jumps to jumps). In such a case, the jump is
61 * replaced by a jump to the final location. This will in some cases produce
62 * worse code, because some jump targets are no longer reachable by short
63 * branches, but this is quite rare, so there are more advantages than
67 unsigned OptRTS (CodeSeg* S);
68 /* Optimize subroutine calls followed by an RTS. The subroutine call will get
69 * replaced by a jump. Don't bother to delete the RTS if it does not have a
70 * label, the dead code elimination should take care of it.
73 unsigned OptJumpTarget (CodeSeg* S);
74 /* If the instruction preceeding an unconditional branch is the same as the
75 * instruction preceeding the jump target, the jump target may be moved
76 * one entry back. This is a size optimization, since the instruction before
77 * the branch gets removed.
80 unsigned OptCondBranches (CodeSeg* S);
81 /* If an immidiate load of a register is followed by a conditional jump that
82 * is never taken because the load of the register sets the flags in such a
83 * manner, remove the conditional branch.
86 unsigned OptUnusedLoads (CodeSeg* S);
87 /* Remove loads of registers where the value loaded is not used later. */
89 unsigned OptBranchDist (CodeSeg* S);
90 /* Change branches for the distance needed. */
94 /* End of coptind.h */