# Copyright (C) 2018 EETS GmbH - http://www.eets.ch/
#
# SPDX-License-Identifier: GPL-2.0+
#

if TARGET_PDU001

config SYS_BOARD
	default "pdu001"

config SYS_VENDOR
	default "eets"

config SYS_SOC
	default "am33xx"

config SYS_CONFIG_NAME
	default "pdu001"

config CONS_INDEX
	int "UART used for console"
	range 1 6
	default 4
	help
	  The AM335x SoC has a total of 6 UARTs (UART0 to UART5 as referenced
	  in documentation, etc) available to it.  The best choice for the
	  PDU001 is UART3 as it is wired to the header K2; enter 4 here to
	  use UART3. UART0 is connected to the EIA-485 transceiver. If you
	  really need to use it, you are advised to remove the transceiver U14
	  from the board. UART1 is wired to the backplane and therefore
	  accessible from there or by the backplane connector K1 of the PDU.
	  Any other UART then UART3 (enter 4 here), UART1 (enter 2 here) or
	  UART0 (enter 1 here) are not sensible since they are not wired to
	  any connector and therefore difficult to access.

choice
	prompt "State of Run LED"
	default PDU001_RUN_LED_RED
	help
	  The PDU001 has a bi-color (red/green) LED labeled 'Run' which
	  can be used to indicate the operating state of the board. By
	  default it will be lit red by U-Boot. Later in the start-up
	  process it can be changed to green (or heartbeat or anything else)
	  by the kernel or some other software.

config RUN_LED_RED
	bool
	prompt "Red"
	help
	  Lit Run LED red.

config RUN_LED_GREEN
	bool
	prompt "Green"
	help
	  Lit Run LED green.

config RUN_LED_OFF
	bool
	prompt "Off"
	help
	  Do not lit Run LED.

endchoice

endif