/*\r
- FreeRTOS.org V4.6.1 - Copyright (C) 2003-2007 Richard Barry.\r
+ FreeRTOS.org V4.7.0 - Copyright (C) 2003-2007 Richard Barry.\r
\r
This file is part of the FreeRTOS.org distribution.\r
\r
/* Constants to setup the PLL. */\r
#define mainPLL_MUL ( ( unsigned portLONG ) ( 12 - 1 ) )\r
#define mainPLL_DIV ( ( unsigned portLONG ) 0x0000 )\r
-#define mainCPU_CLK_DIV ( ( unsigned portLONG ) 0x0004 )\r
+#define mainCPU_CLK_DIV ( ( unsigned portLONG ) 0x0003 )\r
#define mainPLL_ENABLE ( ( unsigned portLONG ) 0x0001 )\r
#define mainPLL_CONNECT ( ( ( unsigned portLONG ) 0x0002 ) | mainPLL_ENABLE )\r
#define mainPLL_FEED_BYTE1 ( ( unsigned portLONG ) 0xaa )\r
PLLFEED = mainPLL_FEED_BYTE2;\r
while( !( PLLSTAT & mainPLL_CONNECTED ) ); \r
\r
- /* Setup and turn on the MAM. Three cycle access is used due to the fast\r
+ /* \r
+ This code is commented out as the MAM does not work on the original revision\r
+ LPC2368 chips. If using Rev B chips then you can increase the speed though\r
+ the use of the MAM.\r
+ \r
+ Setup and turn on the MAM. Three cycle access is used due to the fast\r
PLL used. It is possible faster overall performance could be obtained by\r
- tuning the MAM and PLL settings. */\r
+ tuning the MAM and PLL settings.\r
MAMCR = 0;\r
MAMTIM = mainMAM_TIM_3;\r
MAMCR = mainMAM_MODE_FULL;\r
+ */\r
\r
/* Setup the led's on the MCB2300 board */\r
vParTestInitialise();\r