JTAG Layer:
New driver for "Bus Pirate"
+ Rename various commands so they're not JTAG-specific
+ There are migration procedures for most of these, but you should
+ convert your scripts to the new names, since those procedures
+ will not be around forever.
+ jtag jinterface ... is now adapter_name
+ jtag_khz ... is now adapter_khz
+ jtag_nsrst_delay ... is now adapter_nsrst_delay
+ jtag_nsrst_assert_width ... is now adapter_nsrst_assert_width
+ Support Voipac VPACLink JTAG Adapter.
Boundary Scan:
+Transport framework core ... supporting future work for SWD, SPI, and other
+non-JTAG ways to debug targets or program flash.
+
Target Layer:
+ ARM:
+ - basic semihosting support for ARMv7M.
+ - renamed "armv7m" command prefix as "arm"
+ MIPS:
+ - "ejtag_srst" variant removed. The same functionality is
+ obtained by using "reset_config none".
+ - added PIC32MX software reset support, this means srst is not
+ required to be connected anymore.
+ OTHER:
+ - preliminary AVR32 AP7000 support.
Flash Layer:
New "stellaris recover" command, implements the procedure
state to the factory defaults, including erasing
the flash and its protection bits, and possibly
re-enabling hardware debugging).
-
+ PIC32MX now uses algorithm for flash programming, this
+ has increased the performance by approx 96%.
+ New 'pic32mx unlock' cmd to remove readout protection.
+ New STM32 Value Line Support.
+ New 'virtual' flash driver, used to associate other addresses
+ with a flash bank. See pic32mx.cfg for usage.
+ New iMX27 NAND flash controller driver.
Board, Target, and Interface Configuration Scripts:
Support IAR LPC1768 kickstart board (by Olimex)
+ Support Voipac PXA270/PXA270M module.
+ New $PARPORTADDR tcl variable used to change default
+ parallel port address used.
+ Remove lm3s811.cfg; use "stellaris.cfg" instead
Core Jim/TCL Scripting:
+ New "add_script_search_dir" command, behaviour is the same
+ as the "-s" cmd line option.
Documentation: