altera_uart: change ioremap to map_physmem

[u-boot] / README

diff --git a/README b/README
index c0a9ea0ed8b6be651dc8b97439fab713b8ca3522..32c5ea66531302af1d311d5fbc94e98abdfa17ee 100644 (file)
--- a/README
+++ b/README
@@ -1472,8 +1472,8 @@ The following options need to be configured:
                CONFIG_TPM
                Support TPM devices.
 
-               CONFIG_TPM_TIS_I2C
-               Support for i2c bus TPM devices. Only one device
+               CONFIG_TPM_TIS_INFINEON
+               Support for Infineon i2c bus TPM devices. Only one device
                per system is supported at this time.
 
                        CONFIG_TPM_TIS_I2C_BURST_LIMITATION
@@ -2438,6 +2438,15 @@ CBFS (Coreboot Filesystem) support
                  - CONFIG_SYS_I2C_IHS_CH3 activate hardware channel 3
                  - CONFIG_SYS_I2C_IHS_SPEED_3 speed channel 3
                  - CONFIG_SYS_I2C_IHS_SLAVE_3 slave addr channel 3
+                 - activate dual channel with CONFIG_SYS_I2C_IHS_DUAL
+                 - CONFIG_SYS_I2C_IHS_SPEED_0_1 speed channel 0_1
+                 - CONFIG_SYS_I2C_IHS_SLAVE_0_1 slave addr channel 0_1
+                 - CONFIG_SYS_I2C_IHS_SPEED_1_1 speed channel 1_1
+                 - CONFIG_SYS_I2C_IHS_SLAVE_1_1 slave addr channel 1_1
+                 - CONFIG_SYS_I2C_IHS_SPEED_2_1 speed channel 2_1
+                 - CONFIG_SYS_I2C_IHS_SLAVE_2_1 slave addr channel 2_1
+                 - CONFIG_SYS_I2C_IHS_SPEED_3_1 speed channel 3_1
+                 - CONFIG_SYS_I2C_IHS_SLAVE_3_1 slave addr channel 3_1
 
                additional defines:
 
@@ -3494,6 +3503,10 @@ FIT uImage format:
                without a fastmap.
                default: 0
 
+               CONFIG_MTD_UBI_FM_DEBUG
+               Enable UBI fastmap debug
+               default: 0
+
 - UBIFS support
                CONFIG_CMD_UBIFS
 
@@ -3564,6 +3577,9 @@ FIT uImage format:
 
                CONFIG_SYS_SPL_MALLOC_START
                Starting address of the malloc pool used in SPL.
+               When this option is set the full malloc is used in SPL and
+               it is set up by spl_init() and before that, the simple malloc()
+               can be used if CONFIG_SYS_MALLOC_F is defined.
 
                CONFIG_SYS_SPL_MALLOC_SIZE
                The size of the malloc pool used in SPL.