CONFIG_SYS_FSL_IFC_LE
Defines the IFC controller register space as Little Endian
+ CONFIG_SYS_FSL_IFC_CLK_DIV
+ Defines divider of platform clock(clock input to IFC controller).
+
+ CONFIG_SYS_FSL_LBC_CLK_DIV
+ Defines divider of platform clock(clock input to eLBC controller).
+
CONFIG_SYS_FSL_PBL_PBI
It enables addition of RCW (Power on reset configuration) in built image.
Please refer doc/README.pblimage for more details
CONFIG_SH_MMCIF_CLK
Define the clock frequency for MMCIF
- CONFIG_GENERIC_MMC
- Enable the generic MMC driver
-
CONFIG_SUPPORT_EMMC_BOOT
Enable some additional features of the eMMC boot partitions.
can be displayed via the splashscreen support or the
bmp command.
-- Do compressing for memory range:
- CONFIG_CMD_ZIP
-
- If this option is set, it would use zlib deflate method
- to compress the specified memory at its best effort.
-
- Compression support:
CONFIG_GZIP
A byte containing the id of the VLAN.
-- Status LED: CONFIG_STATUS_LED
+- Status LED: CONFIG_LED_STATUS
Several configurations allow to display the current
status using a LED. For instance, the LED will blink
soon as a reply to a BOOTP request was received, and
start blinking slow once the Linux kernel is running
(supported by a status LED driver in the Linux
- kernel). Defining CONFIG_STATUS_LED enables this
+ kernel). Defining CONFIG_LED_STATUS enables this
feature in U-Boot.
Additional options:
- CONFIG_GPIO_LED
+ CONFIG_LED_STATUS_GPIO
The status LED can be connected to a GPIO pin.
In such cases, the gpio_led driver can be used as a
- status LED backend implementation. Define CONFIG_GPIO_LED
+ status LED backend implementation. Define CONFIG_LED_STATUS_GPIO
to include the gpio_led driver in the U-Boot binary.
CONFIG_GPIO_LED_INVERTED_TABLE
this is instead controlled by the value of
/config/load-environment.
-- Parallel Flash support:
- CONFIG_SYS_NO_FLASH
-
- Traditionally U-Boot was run on systems with parallel NOR
- flash. This option is used to disable support for parallel NOR
- flash. This option should be defined if the board does not have
- parallel flash.
-
- If this option is not defined one of the generic flash drivers
- (e.g. CONFIG_FLASH_CFI_DRIVER or CONFIG_ST_SMI) must be
- selected or the board must provide an implementation of the
- flash API (see include/flash.h).
-
- DataFlash Support:
CONFIG_HAS_DATAFLASH