USB: Add EHCI support for VCT EHCI controller (really with driver now)

[u-boot] / README

diff --git a/README b/README
index ad792d394fbbf092ba810c3821f6fe8962d4e19c..522471cf781a55ed85e41e23832e5dfa6edf1aa4 100644 (file)
--- a/README
+++ b/README
@@ -1509,6 +1509,15 @@ The following options need to be configured:
                Bus on the MPC8260. But it should be not so difficult
                to add this option to other architectures.
 
+               CONFIG_SOFT_I2C_READ_REPEATED_START
+
+               defining this will force the i2c_read() function in
+               the soft_i2c driver to perform an I2C repeated start
+               between writing the address pointer and reading the
+               data.  If this define is omitted the default behaviour
+               of doing a stop-start sequence will be used.  Most I2C
+               devices can use either method, but some require one or
+               the other.
 
 - SPI Support: CONFIG_SPI
 
@@ -2036,6 +2045,9 @@ Configuration Settings:
 - CONFIG_SYS_LONGHELP: Defined when you want long help messages included;
                undefine this when you're short of memory.
 
+- CONFIG_SYS_HELP_CMD_WIDTH: Defined when you want to override the default
+               width of the commands listed in the 'help' command output.
+
 - CONFIG_SYS_PROMPT:   This is what U-Boot prints on the console to
                prompt for user input.
 
@@ -3009,8 +3021,7 @@ Some configuration options can be set using Environment Variables:
                  Useful on scripts which control the retry operation
                  themselves.
 
-  npe_ucode    - see CONFIG_IXP4XX_NPE_EXT_UCOD
-                 if set load address for the NPE microcode
+  npe_ucode    - set load address for the NPE microcode
 
   tftpsrcport  - If this is set, the value is used for TFTP's
                  UDP source port.