SPL: Move SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION to Kconfig

[u-boot] / common / spl / Kconfig

diff --git a/common/spl/Kconfig b/common/spl/Kconfig
index 3e71817b69e1787130bbf1e204682f63f413689d..60ae60c17e3e8582160a3a071fec0655daa51732 100644 (file)
--- a/common/spl/Kconfig
+++ b/common/spl/Kconfig
@@ -96,6 +96,36 @@ config SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR
          Address on the MMC to load U-Boot from, when the MMC is being used
          in raw mode. Units: MMC sectors (1 sector = 512 bytes).
 
+config SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION
+       bool "MMC Raw mode: by partition"
+       depends on SPL
+       help
+         Use a partition for loading U-Boot when using MMC/SD in raw mode.
+
+config SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION
+       hex "Partition to use to load U-Boot from"
+       depends on SPL && SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION
+       default 1
+       help
+         Partition on the MMC to load U-Boot from when the MMC is being
+         used in raw mode
+
+config SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION_TYPE
+       bool "MMC raw mode: by partition type"
+       depends on SPL && DOS_PARTITION && \
+               SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION
+       help
+         Use partition type for specifying U-Boot partition on MMC/SD in
+         raw mode. U-Boot will be loaded from the first partition of this
+         type to be found.
+
+config SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_TYPE
+       hex "Partition Type on the MMC to load U-Boot from"
+       depends on SPL && SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION_TYPE
+       help
+         Partition Type on the MMC to load U-Boot from, when the MMC is being
+         used in raw mode.
+
 config TPL
        bool
        depends on SPL && SUPPORT_TPL
@@ -444,6 +474,15 @@ config SPL_PCI_SUPPORT
          necessary driver support. This enables the drivers in drivers/pci
          as part of an SPL build.
 
+config SPL_PCH_SUPPORT
+       bool "Support PCH drivers"
+       depends on SPL
+       help
+         Enable support for PCH (Platform Controller Hub) devices in SPL.
+         These are used to set up GPIOs and the SPI peripheral early in
+         boot. This enables the drivers in drivers/pch as part of an SPL
+         build.
+
 config SPL_POST_MEM_SUPPORT
        bool "Support POST drivers"
        depends on SPL