options must be configured:
CONFIG_USB_GADGET_DOWNLOAD
-CONFIG_G_DNL_VENDOR_NUM
-CONFIG_G_DNL_PRODUCT_NUM
-CONFIG_G_DNL_MANUFACTURER
+CONFIG_USB_GADGET_VENDOR_NUM
+CONFIG_USB_GADGET_PRODUCT_NUM
+CONFIG_USB_GADGET_MANUFACTURER
-NOTE: The CONFIG_G_DNL_VENDOR_NUM must be one of the numbers supported by
+NOTE: The CONFIG_USB_GADGET_VENDOR_NUM must be one of the numbers supported by
the fastboot client. The list of vendor IDs supported can be found in the
fastboot client source code (fastboot.c) mentioned above.
The fastboot protocol requires a large memory buffer for downloads. This
buffer should be as large as possible for a platform. The location of the
-buffer and size are set with CONFIG_USB_FASTBOOT_BUF_ADDR and
-CONFIG_USB_FASTBOOT_BUF_SIZE.
+buffer and size are set with CONFIG_FASTBOOT_BUF_ADDR and
+CONFIG_FASTBOOT_BUF_SIZE.
Fastboot partition aliases can also be defined for devices where GPT
limitations prevent user-friendly partition names such as "boot", "system"
fastboot_partition_alias_<alias partition name>=<actual partition name>
Example: fastboot_partition_alias_boot=LNX
+Partition Names
+===============
+The Fastboot implementation in U-boot allows to write images into disk
+partitions (currently on eMMC). Target partitions are referred on the host
+computer by their names.
+
+For GPT/EFI the respective partition name is used.
+
+For MBR the partitions are referred by generic names according to the
+following schema:
+
+ <device type> <device index letter> <partition index>
+
+Example: hda3, sdb1, usbda1
+
+The device type is as follows:
+
+ * IDE, ATAPI and SATA disks: hd
+ * SCSI disks: sd
+ * USB media: usbd
+ * MMC and SD cards: mmcsd
+ * Disk on chip: docd
+ * other: xx
+
+The device index starts from 'a' and refers to the interface (e.g. USB
+controller, SD/MMC controller) or disk index. The partition index starts
+from 1 and describes the partition number on the particular device.
+
+Writing Partition Table
+=======================
+Fastboot also allows to write the partition table to the media. This can be
+done by writing the respective partition table image to a special target
+"gpt" or "mbr". These names can be customized by defining the following
+configuration options:
+
+CONFIG_FASTBOOT_GPT_NAME
+CONFIG_FASTBOOT_MBR_NAME
+
In Action
=========
Enter into fastboot by executing the fastboot command in u-boot and you