#endif
/* RAMBOOT will be defined automatically in memory section */
-#define MTDIDS_DEFAULT "nor0=physmap-flash.0"
-#define MTDPARTS_DEFAULT "mtdparts=physmap-flash.0:256k(ubootl)," \
+#define MTDIDS_DEFAULT "nor0=physmap-flash.0"
+#define MTDPARTS_DEFAULT "mtdparts=physmap-flash.0:256k(ubootl)," \
"1792k(kernel),13312k(jffs2),256k(uboot)ro,256k(oftree),-(space)"
/*
* Autobooting
*/
-#define CONFIG_BOOTDELAY 3 /* autoboot after 3 seconds */
+#define CONFIG_BOOTDELAY 10 /* autoboot after 10 seconds */
#define CONFIG_ZERO_BOOTDELAY_CHECK /* allow stopping of boot process */
/* even with bootdelay=0 */
-#undef CONFIG_BOOTARGS
+#define CONFIG_BOOT_RETRY_TIME 120 /* Reset if no command is entered */
+#define CONFIG_RESET_TO_RETRY
#define CONFIG_PREBOOT "echo;" \
- "echo Welcome to U-Boot"\
+ "echo Welcome to U-Boot;"\
"echo"
+#define CONFIG_BOOTCOMMAND "go ff300004 0; go ff300004 2 2;" \
+ "bootm ff040000 ff900000 fffc0000"
+#define CONFIG_BOOTARGS "console=ttyPSC0,115200"
+#define CONFIG_EXTRA_ENV_SETTINGS "epson=yes\0"
+
/*
* IPB Bus clocking configuration.
*/
#define CONFIG_SYS_I2C_MODULE 2 /* Select I2C module #1 or #2 */
#define CONFIG_SYS_I2C_SPEED 100000 /* 100 kHz */
#define CONFIG_SYS_I2C_SLAVE 0x7F
+#define CONFIG_SYS_I2C_INIT_MPC5XXX /* Reset devices on i2c bus */
/*
* EEPROM CAT24WC32 configuration
#define CONFIG_SYS_FLASH_BASE 0xfe000000
/*
- * The flash size is autoconfigured, but cpu/mpc5xxx/cpu_init.c needs this
+ * The flash size is autoconfigured, but arch/powerpc/cpu/mpc5xxx/cpu_init.c needs this
* variable defined
*/
#define CONFIG_SYS_FLASH_SIZE 0x02000000
/* Chip Select configuration for NAND flash */
#define CONFIG_SYS_CS1_START 0x20000000
#define CONFIG_SYS_CS1_SIZE 0x90000
-#define CONFIG_SYS_CS1_CFG 0x0002d900
+#define CONFIG_SYS_CS1_CFG 0x00025b00
+
+/* Chip Select configuration for Epson S1D13513 */
+#define CONFIG_SYS_CS3_START 0x10000000
+#define CONFIG_SYS_CS3_SIZE 0x400000
+#define CONFIG_SYS_CS3_CFG 0xffff3d10
/*
* Ethernet configuration
CONFIG_BOOTP_DNS2 | \
CONFIG_BOOTP_SEND_HOSTNAME )
+#define CONFIG_VERSION_VARIABLE 1
+
/*
* Various low-level settings
*/
#define CONFIG_SYS_BOOTCS_START CONFIG_SYS_FLASH_BASE
#define CONFIG_SYS_BOOTCS_SIZE CONFIG_SYS_FLASH_SIZE
-#define CONFIG_SYS_RESET_ADDRESS 0xff000000
+#define CONFIG_SYS_RESET_ADDRESS 0xff000000
/*
* USB settings