#define SPI_TX_BYTE BIT(8) /* transmit with 1 wire byte */
#define SPI_TX_DUAL BIT(9) /* transmit with 2 wires */
#define SPI_TX_QUAD BIT(10) /* transmit with 4 wires */
-
-/* SPI mode_rx flags */
-#define SPI_RX_SLOW BIT(0) /* receive with 1 wire slow */
-#define SPI_RX_FAST BIT(1) /* receive with 1 wire fast */
-#define SPI_RX_DUAL BIT(2) /* receive with 2 wires */
-#define SPI_RX_QUAD BIT(3) /* receive with 4 wires */
-
-/* SPI bus connection options - see enum spi_dual_flash */
-#define SPI_CONN_DUAL_SHARED (1 << 0)
-#define SPI_CONN_DUAL_SEPARATED (1 << 1)
+#define SPI_RX_SLOW BIT(11) /* receive with 1 wire slow */
+#define SPI_RX_DUAL BIT(12) /* receive with 2 wires */
+#define SPI_RX_QUAD BIT(13) /* receive with 4 wires */
/* Header byte that marks the start of the message */
#define SPI_PREAMBLE_END_BYTE 0xec
* @cs: Chip select number (0..n-1)
* @max_hz: Maximum bus speed that this slave can tolerate
* @mode: SPI mode to use for this device (see SPI mode flags)
- * @mode_rx: SPI RX mode to use for this slave (see SPI mode_rx flags)
*/
struct dm_spi_slave_platdata {
unsigned int cs;
uint max_hz;
uint mode;
- u8 mode_rx;
};
#endif /* CONFIG_DM_SPI */
* bus (bus->seq) so does not need to be stored
* @cs: ID of the chip select connected to the slave.
* @mode: SPI mode to use for this slave (see SPI mode flags)
- * @mode_rx: SPI RX mode to use for this slave (see SPI mode_rx flags)
* @wordlen: Size of SPI word in number of bits
* @max_write_size: If non-zero, the maximum number of bytes which can
* be written at once, excluding command bytes.
* @memory_map: Address of read-only SPI flash access.
- * @option: Varies SPI bus options - separate, shared bus.
* @flags: Indication of SPI flags.
*/
struct spi_slave {
unsigned int cs;
#endif
uint mode;
- u8 mode_rx;
unsigned int wordlen;
unsigned int max_write_size;
void *memory_map;
- u8 option;
u8 flags;
#define SPI_XFER_BEGIN BIT(0) /* Assert CS before transfer */
#define SPI_XFER_ONCE (SPI_XFER_BEGIN | SPI_XFER_END)
#define SPI_XFER_MMAP BIT(2) /* Memory Mapped start */
#define SPI_XFER_MMAP_END BIT(3) /* Memory Mapped End */
-#define SPI_XFER_U_PAGE BIT(4)
};
/**
* @node: Node offset to read from
* @plat: Place to put the decoded information
*/
-int spi_slave_ofdata_to_platdata(const void *blob, int node,
+int spi_slave_ofdata_to_platdata(struct udevice *dev,
struct dm_spi_slave_platdata *plat);
/**