ulong entry_point;
u32 size;
u32 flags;
+ void *arg;
};
/*
* This parses the legacy image header information at @header and sets up
* @spl_image according to what is found. If no image header is found, then
* a raw image or bootz is assumed. If CONFIG_SPL_PANIC_ON_RAW_IMAGE is
- * enabled, then this causes a panic. If CONFIG_SPL_ABORT_ON_RAW_IMAGE is
+ * enabled, then this causes a panic. If CONFIG_SPL_RAW_IMAGE_SUPPORT is not
* enabled then U-Boot gives up. Otherwise U-Boot sets up the image using
* spl_set_header_raw_uboot(), or possibly the bootz header.
*
* This jumps into a Linux kernel using the information in @spl_image.
*
* @spl_image: Image description to set up
- * @arg: Argument to pass to Linux (typically a device tree pointer)
*/
-void __noreturn jump_to_image_linux(struct spl_image_info *spl_image,
- void *arg);
+void __noreturn jump_to_image_linux(struct spl_image_info *spl_image);
/**
* spl_start_uboot() - Check if SPL should start the kernel or U-Boot
struct blk_desc *block_dev, int partition);
/**
- * spl_init() - Set up device tree and driver model in SPL if enabled
+ * spl_early_init() - Set up device tree and driver model in SPL if enabled
*
* Call this function in board_init_f() if you want to use device tree and
- * driver model early, before board_init_r() is called. This function will
- * be called from board_init_r() if not called earlier.
+ * driver model early, before board_init_r() is called.
+ *
+ * If this is not called, then driver model will be inactive in SPL's
+ * board_init_f(), and no device tree will be available.
+ */
+int spl_early_init(void);
+
+/**
+ * spl_init() - Set up device tree and driver model in SPL if enabled
+ *
+ * You can optionally call spl_early_init(), then optionally call spl_init().
+ * This function will be called from board_init_r() if not called earlier.
+ *
+ * Both spl_early_init() and spl_init() perform a similar function except that
+ * the latter will not set up the malloc() area if
+ * CONFIG_SPL_STACK_R_MALLOC_SIMPLE_LEN is enabled, since it is assumed to
+ * already be done by a calll to spl_relocate_stack_gd() before board_init_r()
+ * is reached.
+ *
+ * This function will be called from board_init_r() if not called earlier.
*
* If this is not called, then driver model will be inactive in SPL's
* board_init_f(), and no device tree will be available.