X-Git-Url: https://git.sur5r.net/?a=blobdiff_plain;f=README;h=895fef37e81edc66b115fb8885c69707572b369b;hb=6bb6049bf2ecde91b62a4b3d55fa6ee8ed61520e;hp=3c233db068c42e004c2350efecc40586ca149b8b;hpb=65b7fe28a12bbaccc7a0c076f5f9f213150030e7;p=u-boot diff --git a/README b/README index 3c233db068..895fef37e8 100644 --- a/README +++ b/README @@ -818,6 +818,22 @@ The following options need to be configured: as a convenience, when switching between booting from RAM and NFS. +- Bootcount: + CONFIG_BOOTCOUNT_LIMIT + Implements a mechanism for detecting a repeating reboot + cycle, see: + http://www.denx.de/wiki/view/DULG/UBootBootCountLimit + + CONFIG_BOOTCOUNT_ENV + If no softreset save registers are found on the hardware + "bootcount" is stored in the environment. To prevent a + saveenv on all reboots, the environment variable + "upgrade_available" is used. If "upgrade_available" is + 0, "bootcount" is always 0, if "upgrade_available" is + 1 "bootcount" is incremented in the environment. + So the Userspace Applikation must set the "upgrade_available" + and "bootcount" variable to 0, if a boot was successfully. + - Pre-Boot Commands: CONFIG_PREBOOT @@ -4394,6 +4410,9 @@ Low Level (hardware related) configuration options: NOTE : currently only supported on AM335x platforms. +- CONFIG_SPL_AM33XX_ENABLE_RTC32K_OSC: + Enables the RTC32K OSC on AM33xx based plattforms + Freescale QE/FMAN Firmware Support: ----------------------------------- @@ -5233,6 +5252,15 @@ when your kernel is intended to use an initial ramdisk: Load Address: 0x00000000 Entry Point: 0x00000000 +The "dumpimage" is a tool to disassemble images built by mkimage. Its "-i" +option performs the converse operation of the mkimage's second form (the "-d" +option). Given an image built by mkimage, the dumpimage extracts a "data file" +from the image: + + tools/dumpimage -i image -p position data_file + -i ==> extract from the 'image' a specific 'data_file', \ + indexed by 'position' + Installing a Linux Image: -------------------------