X-Git-Url: https://git.sur5r.net/?a=blobdiff_plain;f=README;h=ed79298fd4ea9f09911ac5bbc7860da870d9055a;hb=bc8cb152d8fbea100023917c285129a6d9ccc3ba;hp=4478bad6ef15c10006b61ec67aa087b1e4cda82f;hpb=04c96ed2a6820ba2aee978826f96d464386b8cab;p=u-boot

diff --git a/README b/README
index 4478bad6ef..ed79298fd4 100644
--- a/README
+++ b/README
@@ -1420,10 +1420,6 @@ The following options need to be configured:
 		be at least 4MB.
 
 - MII/PHY support:
-		CONFIG_PHY_ADDR
-
-		The address of PHY on MII bus.
-
 		CONFIG_PHY_CLOCK_FREQ (ppc4xx)
 
 		The clock frequency of the MII bus
@@ -2267,25 +2263,6 @@ The following options need to be configured:
 		A better solution is to properly configure the firewall,
 		but sometimes that is not allowed.
 
-- bootcount support:
-		CONFIG_AT91SAM9XE
-		enable special bootcounter support on at91sam9xe based boards.
-		CONFIG_BOOTCOUNT_RAM
-		enable support for the bootcounter in RAM
-		CONFIG_BOOTCOUNT_I2C
-		enable support for the bootcounter on an i2c (like RTC) device.
-			CONFIG_SYS_I2C_RTC_ADDR = i2c chip address
-			CONFIG_SYS_BOOTCOUNT_ADDR = i2c addr which is used for
-						    the bootcounter.
-			CONFIG_BOOTCOUNT_ALEN = address len
-		CONFIG_BOOTCOUNT_EXT
-		enable support for the bootcounter in EXT filesystem
-			CONFIG_SYS_BOOTCOUNT_ADDR = RAM address used for read
-                                                    and write.
-			CONFIG_SYS_BOOTCOUNT_EXT_INTERFACE = interface
-			CONFIG_SYS_BOOTCOUNT_EXT_DEVPART = device and part
-			CONFIG_SYS_BOOTCOUNT_EXT_NAME = filename
-
 - Show boot progress:
 		CONFIG_SHOW_BOOT_PROGRESS
 
@@ -2505,12 +2482,6 @@ FIT uImage format:
 		kernel. Needed for UBI support.
 
 - UBI support
-		CONFIG_UBI_SILENCE_MSG
-
-		Make the verbose messages from UBI stop printing.  This leaves
-		warnings and errors enabled.
-
-
 		CONFIG_MTD_UBI_WL_THRESHOLD
 		This parameter defines the maximum difference between the highest
 		erase counter value and the lowest erase counter value of eraseblocks
@@ -2572,12 +2543,6 @@ FIT uImage format:
 		Enable UBI fastmap debug
 		default: 0
 
-- UBIFS support
-		CONFIG_UBIFS_SILENCE_MSG
-
-		Make the verbose messages from UBIFS stop printing.  This leaves
-		warnings and errors enabled.
-
 - SPL framework
 		CONFIG_SPL
 		Enable building of SPL globally.