X-Git-Url: https://git.sur5r.net/?a=blobdiff_plain;f=arch%2Farm%2Fcpu%2Farmv7%2Fmx6%2Fsoc.c;h=193ba1240fb3e04b37e21aacf927c7ffd1900fad;hb=412665b46134f93464c09405e02f08ac9c62526d;hp=2ac74b5945f3f42ccc73d59306ec32cae3ea1f0f;hpb=f2f7745825ee5f6bae5b480c8e9c6641a7ffa73b;p=u-boot

diff --git a/arch/arm/cpu/armv7/mx6/soc.c b/arch/arm/cpu/armv7/mx6/soc.c
index 2ac74b5945..193ba1240f 100644
--- a/arch/arm/cpu/armv7/mx6/soc.c
+++ b/arch/arm/cpu/armv7/mx6/soc.c
@@ -29,15 +29,38 @@
 #include <asm/arch/imx-regs.h>
 #include <asm/arch/clock.h>
 #include <asm/arch/sys_proto.h>
+#include <asm/imx-common/boot_mode.h>
+#include <stdbool.h>
+
+struct scu_regs {
+	u32	ctrl;
+	u32	config;
+	u32	status;
+	u32	invalidate;
+	u32	fpga_rev;
+};
 
 u32 get_cpu_rev(void)
 {
-	int system_rev = 0x61000 | CHIP_REV_1_0;
+	struct anatop_regs *anatop = (struct anatop_regs *)ANATOP_BASE_ADDR;
+	u32 reg = readl(&anatop->digprog_sololite);
+	u32 type = ((reg >> 16) & 0xff);
+
+	if (type != MXC_CPU_MX6SL) {
+		reg = readl(&anatop->digprog);
+		type = ((reg >> 16) & 0xff);
+		if (type == MXC_CPU_MX6DL) {
+			struct scu_regs *scu = (struct scu_regs *)SCU_BASE_ADDR;
+			u32 cfg = readl(&scu->config) & 3;
 
-	return system_rev;
+			if (!cfg)
+				type = MXC_CPU_MX6SOLO;
+		}
+	}
+	reg &= 0xff;		/* mx6 silicon revision */
+	return (type << 12) | (reg + 0x10);
 }
 
-#ifdef CONFIG_ARCH_CPU_INIT
 void init_aips(void)
 {
 	struct aipstz_regs *aips1, *aips2;
@@ -71,12 +94,60 @@ void init_aips(void)
 	writel(0x00000000, &aips2->opacr4);
 }
 
+/*
+ * Set the VDDSOC
+ *
+ * Mask out the REG_CORE[22:18] bits (REG2_TRIG) and set
+ * them to the specified millivolt level.
+ * Possible values are from 0.725V to 1.450V in steps of
+ * 0.025V (25mV).
+ */
+void set_vddsoc(u32 mv)
+{
+	struct anatop_regs *anatop = (struct anatop_regs *)ANATOP_BASE_ADDR;
+	u32 val, reg = readl(&anatop->reg_core);
+
+	if (mv < 725)
+		val = 0x00;	/* Power gated off */
+	else if (mv > 1450)
+		val = 0x1F;	/* Power FET switched full on. No regulation */
+	else
+		val = (mv - 700) / 25;
+
+	/*
+	 * Mask out the REG_CORE[22:18] bits (REG2_TRIG)
+	 * and set them to the calculated value (0.7V + val * 0.25V)
+	 */
+	reg = (reg & ~(0x1F << 18)) | (val << 18);
+	writel(reg, &anatop->reg_core);
+}
+
+static void imx_set_wdog_powerdown(bool enable)
+{
+	struct wdog_regs *wdog1 = (struct wdog_regs *)WDOG1_BASE_ADDR;
+	struct wdog_regs *wdog2 = (struct wdog_regs *)WDOG2_BASE_ADDR;
+
+	/* Write to the PDE (Power Down Enable) bit */
+	writew(enable, &wdog1->wmcr);
+	writew(enable, &wdog2->wmcr);
+}
+
 int arch_cpu_init(void)
 {
 	init_aips();
 
+	set_vddsoc(1200);	/* Set VDDSOC to 1.2V */
+
+	imx_set_wdog_powerdown(false); /* Disable PDE bit of WMCR register */
 	return 0;
 }
+
+#ifndef CONFIG_SYS_DCACHE_OFF
+void enable_caches(void)
+{
+	/* Enable D-cache. I-cache is already enabled in start.S */
+	dcache_enable();
+}
 #endif
 
 #if defined(CONFIG_FEC_MXC)
@@ -99,3 +170,42 @@ void imx_get_mac_from_fuse(int dev_id, unsigned char *mac)
 
 }
 #endif
+
+void boot_mode_apply(unsigned cfg_val)
+{
+	unsigned reg;
+	struct src *psrc = (struct src *)SRC_BASE_ADDR;
+	writel(cfg_val, &psrc->gpr9);
+	reg = readl(&psrc->gpr10);
+	if (cfg_val)
+		reg |= 1 << 28;
+	else
+		reg &= ~(1 << 28);
+	writel(reg, &psrc->gpr10);
+}
+/*
+ * cfg_val will be used for
+ * Boot_cfg4[7:0]:Boot_cfg3[7:0]:Boot_cfg2[7:0]:Boot_cfg1[7:0]
+ * After reset, if GPR10[28] is 1, ROM will copy GPR9[25:0]
+ * to SBMR1, which will determine the boot device.
+ */
+const struct boot_mode soc_boot_modes[] = {
+	{"normal",	MAKE_CFGVAL(0x00, 0x00, 0x00, 0x00)},
+	/* reserved value should start rom usb */
+	{"usb",		MAKE_CFGVAL(0x01, 0x00, 0x00, 0x00)},
+	{"sata",	MAKE_CFGVAL(0x20, 0x00, 0x00, 0x00)},
+	{"escpi1:0",	MAKE_CFGVAL(0x30, 0x00, 0x00, 0x08)},
+	{"escpi1:1",	MAKE_CFGVAL(0x30, 0x00, 0x00, 0x18)},
+	{"escpi1:2",	MAKE_CFGVAL(0x30, 0x00, 0x00, 0x28)},
+	{"escpi1:3",	MAKE_CFGVAL(0x30, 0x00, 0x00, 0x38)},
+	/* 4 bit bus width */
+	{"esdhc1",	MAKE_CFGVAL(0x40, 0x20, 0x00, 0x00)},
+	{"esdhc2",	MAKE_CFGVAL(0x40, 0x28, 0x00, 0x00)},
+	{"esdhc3",	MAKE_CFGVAL(0x40, 0x30, 0x00, 0x00)},
+	{"esdhc4",	MAKE_CFGVAL(0x40, 0x38, 0x00, 0x00)},
+	{NULL,		0},
+};
+
+void s_init(void)
+{
+}