X-Git-Url: https://git.sur5r.net/?a=blobdiff_plain;f=drivers%2Fnet%2Feepro100.c;h=22e14e3814deeadf854b0b09d4494d4038c5b360;hb=e9319f111d366294b9a1e8b1f66875242a5de3dd;hp=738146e6618e08e05656ca28ab879e38e0ff6fb2;hpb=74ac5facb988fc488a707db228b177ead63a6541;p=u-boot diff --git a/drivers/net/eepro100.c b/drivers/net/eepro100.c index 738146e661..22e14e3814 100644 --- a/drivers/net/eepro100.c +++ b/drivers/net/eepro100.c @@ -24,15 +24,13 @@ #include #include #include +#include #include #include #include #undef DEBUG -#if defined(CONFIG_CMD_NET) \ - && defined(CONFIG_NET_MULTI) && defined(CONFIG_EEPRO100) - /* Ethernet chip registers. */ #define SCBStatus 0 /* Rx/Command Unit Status *Word* */ @@ -196,14 +194,14 @@ struct descriptor { /* A generic descriptor. */ unsigned char params[0]; }; -#define CFG_CMD_EL 0x8000 -#define CFG_CMD_SUSPEND 0x4000 -#define CFG_CMD_INT 0x2000 -#define CFG_CMD_IAS 0x0001 /* individual address setup */ -#define CFG_CMD_CONFIGURE 0x0002 /* configure */ +#define CONFIG_SYS_CMD_EL 0x8000 +#define CONFIG_SYS_CMD_SUSPEND 0x4000 +#define CONFIG_SYS_CMD_INT 0x2000 +#define CONFIG_SYS_CMD_IAS 0x0001 /* individual address setup */ +#define CONFIG_SYS_CMD_CONFIGURE 0x0002 /* configure */ -#define CFG_STATUS_C 0x8000 -#define CFG_STATUS_OK 0x2000 +#define CONFIG_SYS_STATUS_C 0x8000 +#define CONFIG_SYS_STATUS_OK 0x2000 /* Misc. */ @@ -323,7 +321,8 @@ static int set_phyreg (struct eth_device *dev, unsigned char addr, /* Check if given phyaddr is valid, i.e. there is a PHY connected. * Do this by checking model value field from ID2 register. */ -static struct eth_device* verify_phyaddr (char *devname, unsigned char addr) +static struct eth_device* verify_phyaddr (const char *devname, + unsigned char addr) { struct eth_device *dev; unsigned short value; @@ -352,7 +351,7 @@ static struct eth_device* verify_phyaddr (char *devname, unsigned char addr) return dev; } -static int eepro100_miiphy_read (char *devname, unsigned char addr, +static int eepro100_miiphy_read(const char *devname, unsigned char addr, unsigned char reg, unsigned short *value) { struct eth_device *dev; @@ -369,7 +368,7 @@ static int eepro100_miiphy_read (char *devname, unsigned char addr, return 0; } -static int eepro100_miiphy_write (char *devname, unsigned char addr, +static int eepro100_miiphy_write(const char *devname, unsigned char addr, unsigned char reg, unsigned short value) { struct eth_device *dev; @@ -485,7 +484,7 @@ int eepro100_initialize (bd_t * bis) static int eepro100_init (struct eth_device *dev, bd_t * bis) { - int i, status = 0; + int i, status = -1; int tx_cur; struct descriptor *ias_cmd, *cfg_cmd; @@ -531,7 +530,7 @@ static int eepro100_init (struct eth_device *dev, bd_t * bis) tx_next = ((tx_next + 1) % NUM_TX_DESC); cfg_cmd = (struct descriptor *) &tx_ring[tx_cur]; - cfg_cmd->command = cpu_to_le16 ((CFG_CMD_SUSPEND | CFG_CMD_CONFIGURE)); + cfg_cmd->command = cpu_to_le16 ((CONFIG_SYS_CMD_SUSPEND | CONFIG_SYS_CMD_CONFIGURE)); cfg_cmd->status = 0; cfg_cmd->link = cpu_to_le32 (phys_to_bus ((u32) & tx_ring[tx_next])); @@ -539,7 +538,7 @@ static int eepro100_init (struct eth_device *dev, bd_t * bis) sizeof (i82558_config_cmd)); if (!wait_for_eepro100 (dev)) { - printf ("Error---CFG_CMD_CONFIGURE: Can not reset ethernet controller.\n"); + printf ("Error---CONFIG_SYS_CMD_CONFIGURE: Can not reset ethernet controller.\n"); goto Done; } @@ -547,7 +546,7 @@ static int eepro100_init (struct eth_device *dev, bd_t * bis) OUTW (dev, SCB_M | CU_START, SCBCmd); for (i = 0; - !(le16_to_cpu (tx_ring[tx_cur].status) & CFG_STATUS_C); + !(le16_to_cpu (tx_ring[tx_cur].status) & CONFIG_SYS_STATUS_C); i++) { if (i >= TOUT_LOOP) { printf ("%s: Tx error buffer not ready\n", dev->name); @@ -555,7 +554,7 @@ static int eepro100_init (struct eth_device *dev, bd_t * bis) } } - if (!(le16_to_cpu (tx_ring[tx_cur].status) & CFG_STATUS_OK)) { + if (!(le16_to_cpu (tx_ring[tx_cur].status) & CONFIG_SYS_STATUS_OK)) { printf ("TX error status = 0x%08X\n", le16_to_cpu (tx_ring[tx_cur].status)); goto Done; @@ -567,7 +566,7 @@ static int eepro100_init (struct eth_device *dev, bd_t * bis) tx_next = ((tx_next + 1) % NUM_TX_DESC); ias_cmd = (struct descriptor *) &tx_ring[tx_cur]; - ias_cmd->command = cpu_to_le16 ((CFG_CMD_SUSPEND | CFG_CMD_IAS)); + ias_cmd->command = cpu_to_le16 ((CONFIG_SYS_CMD_SUSPEND | CONFIG_SYS_CMD_IAS)); ias_cmd->status = 0; ias_cmd->link = cpu_to_le32 (phys_to_bus ((u32) & tx_ring[tx_next])); @@ -583,7 +582,7 @@ static int eepro100_init (struct eth_device *dev, bd_t * bis) OUTL (dev, phys_to_bus ((u32) & tx_ring[tx_cur]), SCBPointer); OUTW (dev, SCB_M | CU_START, SCBCmd); - for (i = 0; !(le16_to_cpu (tx_ring[tx_cur].status) & CFG_STATUS_C); + for (i = 0; !(le16_to_cpu (tx_ring[tx_cur].status) & CONFIG_SYS_STATUS_C); i++) { if (i >= TOUT_LOOP) { printf ("%s: Tx error buffer not ready\n", @@ -592,13 +591,13 @@ static int eepro100_init (struct eth_device *dev, bd_t * bis) } } - if (!(le16_to_cpu (tx_ring[tx_cur].status) & CFG_STATUS_OK)) { + if (!(le16_to_cpu (tx_ring[tx_cur].status) & CONFIG_SYS_STATUS_OK)) { printf ("TX error status = 0x%08X\n", le16_to_cpu (tx_ring[tx_cur].status)); goto Done; } - status = 1; + status = 0; Done: return status; @@ -642,7 +641,7 @@ static int eepro100_send (struct eth_device *dev, volatile void *packet, int len OUTL (dev, phys_to_bus ((u32) & tx_ring[tx_cur]), SCBPointer); OUTW (dev, SCB_M | CU_START, SCBCmd); - for (i = 0; !(le16_to_cpu (tx_ring[tx_cur].status) & CFG_STATUS_C); + for (i = 0; !(le16_to_cpu (tx_ring[tx_cur].status) & CONFIG_SYS_STATUS_C); i++) { if (i >= TOUT_LOOP) { printf ("%s: Tx error buffer not ready\n", dev->name); @@ -650,7 +649,7 @@ static int eepro100_send (struct eth_device *dev, volatile void *packet, int len } } - if (!(le16_to_cpu (tx_ring[tx_cur].status) & CFG_STATUS_OK)) { + if (!(le16_to_cpu (tx_ring[tx_cur].status) & CONFIG_SYS_STATUS_OK)) { printf ("TX error status = 0x%08X\n", le16_to_cpu (tx_ring[tx_cur].status)); goto Done; @@ -944,5 +943,3 @@ static void read_hw_addr (struct eth_device *dev, bd_t * bis) #endif } } - -#endif