X-Git-Url: https://git.sur5r.net/?a=blobdiff_plain;f=include%2Fconfigs%2FBSC9132QDS.h;h=89907dce4b17e8783d1a364f8261ff48f0982ca1;hb=44da3a176c5bd48b7ed257454e3e551c956adb30;hp=aeded6d85b40c436998a39f5036525210d07cb09;hpb=dcdb61a084bd3840d0987a5d01ae506c11efca1b;p=u-boot

diff --git a/include/configs/BSC9132QDS.h b/include/configs/BSC9132QDS.h
index aeded6d85b..89907dce4b 100644
--- a/include/configs/BSC9132QDS.h
+++ b/include/configs/BSC9132QDS.h
@@ -11,6 +11,8 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
+#define CONFIG_DISPLAY_BOARDINFO
+
 #ifdef CONFIG_BSC9132QDS
 #define CONFIG_BSC9132
 #endif
@@ -78,6 +80,7 @@
 #define CONFIG_BOOKE			/* BOOKE */
 #define CONFIG_E500			/* BOOKE e500 family */
 #define CONFIG_FSL_IFC			/* Enable IFC Support */
+#define CONFIG_FSL_CAAM			/* Enable SEC/CAAM */
 #define CONFIG_SYS_HAS_SERDES		/* common SERDES init code */
 
 #define CONFIG_PCI			/* Enable PCI/PCIE */
@@ -88,10 +91,8 @@
 #define CONFIG_FSL_PCIE_RESET		/* need PCIe reset errata */
 #define CONFIG_SYS_PCI_64BIT		/* enable 64-bit PCI resources */
 
-#define CONFIG_CMD_NET
 #define CONFIG_CMD_PCI
 
-#define CONFIG_E1000			/*  E1000 pci Ethernet card*/
 
 /*
  * PCI Windows
@@ -316,7 +317,6 @@ combinations. this should be removed later
 /* NAND */
 #define CONFIG_SYS_NAND_BASE_LIST	{ CONFIG_SYS_NAND_BASE }
 #define CONFIG_SYS_MAX_NAND_DEVICE	1
-#define CONFIG_MTD_NAND_VERIFY_WRITE
 #define CONFIG_CMD_NAND
 
 #define CONFIG_SYS_NAND_BLOCK_SIZE	(128 * 1024)
@@ -408,7 +408,6 @@ combinations. this should be removed later
 /* Serial Port */
 #define CONFIG_CONS_INDEX	1
 #undef	CONFIG_SERIAL_SOFTWARE_FIFO
-#define CONFIG_SYS_NS16550
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE	1
 #define CONFIG_SYS_NS16550_CLK		get_bus_freq(0)
@@ -416,7 +415,6 @@ combinations. this should be removed later
 #define CONFIG_NS16550_MIN_FUNCTIONS
 #endif
 
-#define CONFIG_SERIAL_MULTI	1 /* Enable both serial ports */
 #define CONFIG_SYS_CONSOLE_IS_IN_ENV	/* determine from environment */
 
 #define CONFIG_SYS_BAUDRATE_TABLE	\
@@ -464,7 +462,6 @@ combinations. this should be removed later
 
 /* enable read and write access to EEPROM */
 #define CONFIG_CMD_EEPROM
-#define CONFIG_SYS_I2C_MULTI_EEPROMS
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
@@ -481,10 +478,7 @@ combinations. this should be removed later
  * used for SLIC
  */
 /* eSPI - Enhanced SPI */
-#define CONFIG_FSL_ESPI  /* SPI */
 #ifdef CONFIG_FSL_ESPI
-#define CONFIG_SPI_FLASH
-#define CONFIG_SPI_FLASH_SPANSION
 #define CONFIG_CMD_SF
 #define CONFIG_SF_DEFAULT_SPEED		10000000
 #define CONFIG_SF_DEFAULT_MODE		SPI_MODE_0
@@ -579,17 +573,13 @@ combinations. this should be removed later
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
 #define CONFIG_CMD_DATE
 #define CONFIG_CMD_DHCP
-#define CONFIG_CMD_ELF
 #define CONFIG_CMD_ERRATA
 #define CONFIG_CMD_I2C
 #define CONFIG_CMD_IRQ
 #define CONFIG_CMD_MII
 #define CONFIG_CMD_PING
-#define CONFIG_CMD_SETEXPR
 #define CONFIG_CMD_REGINFO
 
 #if defined(CONFIG_MMC) || defined(CONFIG_USB_EHCI)
@@ -598,6 +588,12 @@ combinations. this should be removed later
 #define CONFIG_DOS_PARTITION
 #endif
 
+/* Hash command with SHA acceleration supported in hardware */
+#ifdef CONFIG_FSL_CAAM
+#define CONFIG_CMD_HASH
+#define CONFIG_SHA_HW_ACCEL
+#endif
+
 /*
  * Miscellaneous configurable options
  */
@@ -629,6 +625,27 @@ combinations. this should be removed later
 #define CONFIG_KGDB_BAUDRATE	230400	/* speed to run kgdb serial port */
 #endif
 
+/*
+ * Dynamic MTD Partition support with mtdparts
+ */
+#ifndef CONFIG_SYS_NO_FLASH
+#define CONFIG_MTD_DEVICE
+#define CONFIG_MTD_PARTITIONS
+#define CONFIG_CMD_MTDPARTS
+#define CONFIG_FLASH_CFI_MTD
+#define MTDIDS_DEFAULT "nor0=88000000.nor,nand0=ff800000.flash,"
+#define MTDPARTS_DEFAULT "mtdparts=88000000.nor:256k(dtb),7m(kernel)," \
+			"55m(fs),1m(uboot);ff800000.flash:1m(uboot)," \
+			"8m(kernel),512k(dtb),-(fs)"
+#endif
+/*
+ * Override partitions in device tree using info
+ * in "mtdparts" environment variable
+ */
+#ifdef CONFIG_CMD_MTDPARTS
+#define CONFIG_FDT_FIXUP_PARTITIONS
+#endif
+
 /*
  * Environment Configuration
  */
@@ -644,6 +661,7 @@ combinations. this should be removed later
 #define CONFIG_UBOOTPATH	"u-boot.bin"
 
 #define CONFIG_BAUDRATE		115200
+#define CONFIG_BOOTDELAY	10 /* -1 disable auto-boot */
 
 #ifdef CONFIG_SDCARD
 #define CONFIG_DEF_HWCONFIG	"hwconfig=usb1:dr_mode=host,phy_type=ulpi\0"