X-Git-Url: https://git.sur5r.net/?a=blobdiff_plain;f=include%2Fconfigs%2Fdavinci_sffsdr.h;h=307b9f27419b02645cfb7b6d9f2d83c97ede55f5;hb=810c44274980d8bb9fa0d81d091a374adbae8309;hp=71d48fb912077da85ad2855b59b4d259e662e099;hpb=9efe379a0eb127e616d780533a711f99b52ea64a;p=u-boot

diff --git a/include/configs/davinci_sffsdr.h b/include/configs/davinci_sffsdr.h
index 71d48fb912..307b9f2741 100644
--- a/include/configs/davinci_sffsdr.h
+++ b/include/configs/davinci_sffsdr.h
@@ -42,7 +42,6 @@
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS	20
 /* Memory Info */
 #define CONFIG_SYS_MALLOC_LEN		(0x10000 + 256*1024)	/* malloc() len */
-#define CONFIG_SYS_GBL_DATA_SIZE	128		/* reserved for initial data */
 #define CONFIG_SYS_MEMTEST_START	0x80000000	/* memtest start address */
 #define CONFIG_SYS_MEMTEST_END		0x81000000	/* 16MB RAM test */
 #define CONFIG_NR_DRAM_BANKS	1		/* we have 1 bank of DRAM */
@@ -66,6 +65,7 @@
 #define CONFIG_SYS_I2C_SLAVE		10	/* Bogus, master-only in U-Boot */
 /* Network & Ethernet Configuration */
 #define CONFIG_DRIVER_TI_EMAC
+#define CONFIG_EMAC_MDIO_PHY_NUM	1
 #define CONFIG_MII
 #define CONFIG_BOOTP_DEFAULT
 #define CONFIG_BOOTP_DNS
@@ -78,16 +78,15 @@
 #undef CONFIG_ENV_IS_IN_FLASH
 #define CONFIG_SYS_NO_FLASH
 #define CONFIG_NAND_DAVINCI
+#define CONFIG_SYS_NAND_CS		2
 #define CONFIG_ENV_IS_IN_NAND		/* U-Boot env in NAND Flash  */
 #define CONFIG_ENV_SECT_SIZE	2048	/* Env sector Size */
 #define CONFIG_ENV_SIZE		(128 << 10)	/* 128 KiB */
 #define CONFIG_SKIP_LOWLEVEL_INIT	/* U-Boot is loaded by a bootloader */
-#define CONFIG_SKIP_RELOCATE_UBOOT	/* to a proper address, init done */
 #define CONFIG_SYS_NAND_BASE		0x02000000
 #define CONFIG_SYS_NAND_HW_ECC
 #define CONFIG_SYS_MAX_NAND_DEVICE	1	/* Max number of NAND devices */
 #define CONFIG_ENV_OFFSET		0x0	/* Block 0--not used by bootcode */
-#define CONFIG_SYS_64BIT_VSPRINTF		/* needed for nand_util.c */
 /* I2C switch definitions for PCA9543 chip */
 #define CONFIG_SYS_I2C_PCA9543_ADDR		0x70
 #define CONFIG_SYS_I2C_PCA9543_ADDR_LEN	0	/* Single register. */
@@ -144,9 +143,13 @@
 #undef CONFIG_CMD_SETGETDCR
 #undef CONFIG_CMD_FLASH
 #undef CONFIG_CMD_IMLS
-/* KGDB support (if any) */
-#ifdef CONFIG_CMD_KGDB
-#define CONFIG_KGDB_BAUDRATE	115200	/* speed to run kgdb serial port */
-#define CONFIG_KGDB_SER_INDEX	1	/* which serial port to use */
-#endif
+
+#define CONFIG_MAX_RAM_BANK_SIZE	(256 << 20)	/* 256 MB */
+
+#define CONFIG_SYS_SDRAM_BASE		PHYS_SDRAM_1
+#define CONFIG_SYS_INIT_RAM_SIZE	0x1000
+#define CONFIG_SYS_INIT_SP_ADDR		(CONFIG_SYS_SDRAM_BASE + \
+					 CONFIG_SYS_INIT_RAM_SIZE - \
+					 GENERATED_GBL_DATA_SIZE)
+
 #endif /* __CONFIG_H */