X-Git-Url: https://git.sur5r.net/?a=blobdiff_plain;f=include%2Fconfigs%2Finka4x0.h;h=773d5d2c1d963374b0923f8da78e359fbe0390b8;hb=4bbd4537835f72b5c46ca6efb38143e431b3dbd5;hp=82a384202cf37c5876a878dea83febdfeb7df90c;hpb=414eec35e3832f4f9ce8a25ace7ead638be1f76f;p=u-boot

diff --git a/include/configs/inka4x0.h b/include/configs/inka4x0.h
index 82a384202c..773d5d2c1d 100644
--- a/include/configs/inka4x0.h
+++ b/include/configs/inka4x0.h
@@ -101,7 +101,7 @@
 /*
  * Autobooting
  */
-#define CONFIG_BOOTDELAY	5	/* autoboot after 5 seconds */
+#define CONFIG_BOOTDELAY	1	/* autoboot after 1 second */
 
 #define CONFIG_PREBOOT	"echo;" \
 	"echo Type \"run flash_nfs\" to mount root filesystem over NFS;" \
@@ -109,21 +109,40 @@
 
 #undef	CONFIG_BOOTARGS
 
+#define	CONFIG_ETHADDR		00:a0:a4:03:00:00
+#define	CONFIG_OVERWRITE_ETHADDR_ONCE
+
+#define	CONFIG_IPADDR		192.168.100.2
+#define	CONFIG_SERVERIP		192.168.100.1
+#define	CONFIG_NETMASK		255.255.255.0
+#define HOSTNAME		inka4x0
+#define CONFIG_BOOTFILE		/tftpboot/inka4x0/uImage
+#define	CONFIG_ROOTPATH		/opt/eldk/ppc_6xx
+
 #define CONFIG_EXTRA_ENV_SETTINGS					\
 	"netdev=eth0\0"							\
 	"nfsargs=setenv bootargs root=/dev/nfs rw "			\
-		"nfsroot=$(serverip):$(rootpath)\0"			\
+		"nfsroot=${serverip}:${rootpath}\0"			\
 	"ramargs=setenv bootargs root=/dev/ram rw\0"			\
-	"addip=setenv bootargs $(bootargs) "				\
-		"ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask)"	\
-		":$(hostname):$(netdev):off panic=1\0"			\
-	"flash_nfs=run nfsargs addip;"					\
-		"bootm $(kernel_addr)\0"				\
-	"net_nfs=tftp 200000 $(bootfile);run nfsargs addip;bootm\0"	\
-	"rootpath=/opt/eldk/ppc_82xx\0"					\
+	"addip=setenv bootargs ${bootargs} "				\
+		"ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}"	\
+		":${hostname}:${netdev}:off panic=1\0"			\
+	"addcons=setenv bootargs ${bootargs} "				\
+		"console=ttyS0,${baudrate}\0"				\
+	"flash_nfs=run nfsargs addip addcons;"				\
+		"bootm ${kernel_addr}\0"				\
+	"net_nfs=tftp 200000 ${bootfile};"				\
+		"run nfsargs addip addcons;bootm\0"			\
+	"enable_disp=mw.l 100000 04000000 1;"				\
+		"cp.l 100000 f0000b20 1;"				\
+		"cp.l 100000 f0000b28 1\0"				\
+	"ideargs=setenv bootargs root=/dev/hda1 rw\0"			\
+	"ide_boot=ext2load ide 0:1 200000 uImage;"			\
+		"run ideargs addip addcons enable_disp;bootm"		\
+	"brightness=255\0"						\
 	""
 
-#define CONFIG_BOOTCOMMAND	"run net_nfs"
+#define CONFIG_BOOTCOMMAND	"run ide_boot"
 
 /*
  * IPB Bus clocking configuration.
@@ -193,12 +212,13 @@
  */
 /* #define CONFIG_FEC_10MBIT 1 */
 #define CONFIG_PHY_ADDR		0x00
+#define CONFIG_MII
 
 /*
  * GPIO configuration
  *
- * use pin gpio_wkup_6 as second SDRAM chip select (mem_cs1):
- *	Bit 0 (mask: 0x80000000): 1
+ * use CS1 as gpio_wkup_6 output
+ *	Bit 0 (mask: 0x80000000): 0
  * use ALT CAN position: Bits 2-3 (mask: 0x30000000):
  *	00 -> No Alternatives, I2C1 is used for onboard EEPROM
  *	01 -> CAN1 on I2C1, CAN2 on Tmr0/1 do not use on TQM5200 with onboard
@@ -206,14 +226,8 @@
  * use PSC1 as UART: Bits 28-31 (mask: 0x00000007): 0100
  * use PSC6_1 and PSC6_3 as GPIO: Bits 9:11 (mask: 0x07000000):
  *	011 -> PSC6 could not be used as UART or CODEC. IrDA still possible.
- * GPIO on PSC6_3 is used in post_hotkeys_pressed() to enable extended POST
- * tests.
  */
-#if defined (CONFIG_MINIFAP)
-#define CFG_GPS_PORT_CONFIG	0x93000004
-#else
-#define CFG_GPS_PORT_CONFIG	0x81001004
-#endif
+#define CFG_GPS_PORT_CONFIG	0x01001004
 
 /*
  * RTC configuration
@@ -311,22 +325,14 @@
 #define CFG_IDE_MAXDEVICE	2	/* max. 1 drive per IDE bus	*/
 
 #define CFG_ATA_IDE0_OFFSET	0x0000
-
 #define CFG_ATA_BASE_ADDR	MPC5XXX_ATA
-
-/* Offset for data I/O			*/
-#define CFG_ATA_DATA_OFFSET	(0x0060)
-
-/* Offset for normal register accesses	*/
-#define CFG_ATA_REG_OFFSET	(CFG_ATA_DATA_OFFSET)
-
-/* Offset for alternate registers	*/
-#define CFG_ATA_ALT_OFFSET	(0x005C)
-
-/* Interval between registers                                                */
-#define CFG_ATA_STRIDE          4
+#define CFG_ATA_DATA_OFFSET	0x0060	/* Offset for data I/O		*/
+#define CFG_ATA_REG_OFFSET (CFG_ATA_DATA_OFFSET) /* Offset for normal register accesses */
+#define CFG_ATA_ALT_OFFSET	0x005C	/* Offset for alternate registers */
+#define CFG_ATA_STRIDE          4	/* Interval between registers	*/
 
 #define CONFIG_ATAPI            1
-#define CFG_BRIGHTNESS          0x20
+
+#define CFG_BRIGHTNESS          0xFF	/* LCD Default Brightness (255 = off) */
 
 #endif /* __CONFIG_H */