X-Git-Url: https://git.sur5r.net/?a=blobdiff_plain;f=include%2Fconfigs%2Fxpedite550x.h;h=87c894cccf728b3d00bd8b64fee11174e077c405;hb=2672d5db1d89e94b78c3475d46e16fa23a9d54d8;hp=a849cf9363512fdfd2136553456a9466a4e79da1;hpb=f2b382ea066d02d5ba44870024cc1295e85782ef;p=u-boot

diff --git a/include/configs/xpedite550x.h b/include/configs/xpedite550x.h
index a849cf9363..87c894cccf 100644
--- a/include/configs/xpedite550x.h
+++ b/include/configs/xpedite550x.h
@@ -67,7 +67,7 @@
 #define CONFIG_SPD_EEPROM		/* Use SPD EEPROM for DDR setup */
 #define CONFIG_DDR_SPD
 #define CONFIG_MEM_INIT_VALUE		0xdeadbeef
-#define SPD_EEPROM_ADDRESS1			0x54
+#define SPD_EEPROM_ADDRESS			0x54
 #define SPD_EEPROM_OFFSET		0x200	/* OFFSET of SPD in EEPROM */
 #define CONFIG_NUM_DDR_CONTROLLERS	1
 #define CONFIG_DIMM_SLOTS_PER_CTLR	1
@@ -93,14 +93,8 @@ extern unsigned long get_board_ddr_clk(unsigned long dummy);
 #define CONFIG_BTB			/* toggle branch predition */
 #define CONFIG_ENABLE_36BIT_PHYS	1
 
-/*
- * Base addresses -- Note these are effective addresses where the
- * actual resources get mapped (not physical addresses)
- */
-#define CONFIG_SYS_CCSRBAR_DEFAULT	0xff700000	/* CCSRBAR Default */
-#define CONFIG_SYS_CCSRBAR		0xef000000	/* relocated CCSRBAR */
-#define CONFIG_SYS_CCSRBAR_PHYS	CONFIG_SYS_CCSRBAR	/* physical addr of CCSRBAR */
-#define CONFIG_SYS_IMMR		CONFIG_SYS_CCSRBAR	/* PQII uses CONFIG_SYS_IMMR */
+#define CONFIG_SYS_CCSRBAR		0xef000000
+#define CONFIG_SYS_CCSRBAR_PHYS_LOW	CONFIG_SYS_CCSRBAR
 
 /*
  * Diagnostics
@@ -214,10 +208,9 @@ extern unsigned long get_board_ddr_clk(unsigned long dummy);
  */
 #define CONFIG_SYS_INIT_RAM_LOCK	1
 #define CONFIG_SYS_INIT_RAM_ADDR	0xe0000000
-#define CONFIG_SYS_INIT_RAM_END		0x00004000
+#define CONFIG_SYS_INIT_RAM_SIZE		0x00004000
 
-#define CONFIG_SYS_GBL_DATA_SIZE	128	/* num bytes initial data */
-#define CONFIG_SYS_GBL_DATA_OFFSET	(CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define CONFIG_SYS_GBL_DATA_OFFSET	(CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 #define CONFIG_SYS_INIT_SP_OFFSET	CONFIG_SYS_GBL_DATA_OFFSET
 
 #define CONFIG_SYS_MONITOR_LEN		(512 * 1024)	/* Reserve 512 KB for Mon */
@@ -340,12 +333,21 @@ extern unsigned long get_board_ddr_clk(unsigned long dummy);
  */
 #define CONFIG_TSEC_ENET		/* tsec ethernet support */
 #define CONFIG_PHY_GIGE		1	/* Include GbE speed/duplex detection */
-#define CONFIG_NET_MULTI	1
 #define CONFIG_TSEC_TBI
 #define CONFIG_MII		1	/* MII PHY management */
 #define CONFIG_MII_DEFAULT_TSEC	1	/* Allow unregistered phys */
 #define CONFIG_ETHPRIME		"eTSEC2"
 
+/*
+ * In-band SGMII auto-negotiation between TBI and BCM5482S PHY fails, force
+ * 1000mbps SGMII link
+ */
+#define CONFIG_TSEC_TBICR_SETTINGS ( \
+		TBICR_PHY_RESET \
+		| TBICR_FULL_DUPLEX \
+		| TBICR_SPEED1_SET \
+		)
+
 #define CONFIG_TSEC1		1
 #define CONFIG_TSEC1_NAME	"eTSEC1"
 #define TSEC1_FLAGS		(TSEC_GIGABIT | TSEC_REDUCED)
@@ -432,12 +434,6 @@ extern unsigned long get_board_ddr_clk(unsigned long dummy);
 #define CONFIG_SYS_BOOTMAPSZ	(16 << 20)	/* Initial Memory map for Linux*/
 #define CONFIG_SYS_BOOTM_LEN	(16 << 20)	/* Increase max gunzip size */
 
-/*
- * Boot Flags
- */
-#define BOOTFLAG_COLD		0x01		/* Normal Power-On: Boot from FLASH */
-#define BOOTFLAG_WARM		0x02		/* Software reboot */
-
 /*
  * Environment Configuration
  */