MailCommand} are also done for this command. Normally, you will set this
command to the same value as specified for the {\bf MailCommand}.
-\item [Debug = \lt{}debug-level\gt{}]
- \index[fd]{Debug}
- This sets the debug message level to the debug level, which is an integer.
-Higher debug levels cause more debug information to be produced. You are
-requested not to use this record since it will be deprecated.
-
\item [\lt{}destination\gt{} = \lt{}message-type1\gt{},
\lt{}message-type2\gt{}, ...]
\index[fd]{\lt{}destination\gt{}}
\index[general]{Supported Operating Systems }
\begin{itemize}
-\item Linux systems (built and tested on SuSE 10.1).
+\item Linux systems (built and tested on SuSE 10.2).
\item Most flavors of Linux (Gentoo, Red Hat, Fedora, Mandriva, Debian, Ubuntu, ...).
\item Solaris various versions.
\item FreeBSD (tape driver supported in 1.30 -- for FreeBSD older than
considerably less secure than PKI certificate-based authentication.
Appropriate autoconf macros have been added to detect and use OpenSSL
-if enabled on the {\bf ./configure} line with {\bf \verb?--?enable-openssl}
+if enabled on the {\bf ./configure} line with {\bf \verb?--?with-openssl}
\section{TLS Configuration Directives}
Additional configuration directives have been added to all the daemons