lm3748: use new Stellaris config file

Use the new file, and remove the old target/lm3s3748.cfg one.

Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>

diff --git a/tcl/board/ek-lm3s3748.cfg b/tcl/board/ek-lm3s3748.cfg
index 1d56c7f4e42dd0f1cf993d76ecb5807ab3600d0c..950e5119c99669448e57de87fcc4b63ff9e84f0b 100644 (file)
--- a/tcl/board/ek-lm3s3748.cfg
+++ b/tcl/board/ek-lm3s3748.cfg
@@ -4,10 +4,7 @@
 # NOTE:  to use the on-board FT2232 JTAG interface:
 #  source [find interface/luminary.cfg]
 
-source [find target/lm3s3748.cfg]
-
-# LM3S parts don't support RTCK
-jtag_khz 500
+source [find target/stellaris.cfg]
 
 # Board has only srst
 reset_config srst_only

diff --git a/tcl/target/lm3s3748.cfg b/tcl/target/lm3s3748.cfg
deleted file mode 100644 (file)
index 274377a..0000000
--- a/tcl/target/lm3s3748.cfg
+++ /dev/null
@@ -1,29 +0,0 @@
-# TI/Luminary Stellaris lm3s3748
-
-if { [info exists CHIPNAME] } {
-   set  _CHIPNAME $CHIPNAME
-} else {
-   set  _CHIPNAME lm3s3748
-}
-
-if { [info exists CPUTAPID ] } {
-   set _CPUTAPID $CPUTAPID
-} else {
-   set _CPUTAPID 0x3ba00477
-}
-
-# JTAG scan chain
-jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 1 -irmask 0xf -expected-id $_CPUTAPID
-
-# The "lm3s" variant works around an erratum when using Rev A of "DustDevil"
-# parts (third generation, includes LM3S3748).  It keeps the debug registers
-# from being cleared, by using software reset not SRST; NOP on newer revs.
-set _TARGETNAME $_CHIPNAME.cpu
-target create $_TARGETNAME cortex_m3 -chain-position $_CHIPNAME.cpu -variant lm3s
-
-# 8k working area at base of ram, not backed up
-$_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size 0x2000
-
-# flash configuration -- one bank of 128K
-set _FLASHNAME $_CHIPNAME.flash
-flash bank $_FLASHNAME stellaris 0 0 0 0 $_TARGETNAME