From: Peter Tyser Date: Tue, 21 Jul 2009 18:51:08 +0000 (-0500) Subject: xpedite5370: Enable NAND command support X-Git-Tag: v2009.08-rc1~36^2^2~1 X-Git-Url: https://git.sur5r.net/?a=commitdiff_plain;h=0a6d0c6320b77bd6572393a93e6b8ccdf39c7100;p=u-boot xpedite5370: Enable NAND command support Use the MPC8572's eLBC to access 1 GB (or greater) onboard NAND flash via the 'nand' command. Previously, the XPedite5370's NAND chip selects were properly configured, but NAND support was not enabled. Signed-off-by: Peter Tyser Signed-off-by: Kumar Gala --- diff --git a/include/configs/XPEDITE5370.h b/include/configs/XPEDITE5370.h index 83f50c4910..acb62ad1dd 100644 --- a/include/configs/XPEDITE5370.h +++ b/include/configs/XPEDITE5370.h @@ -124,6 +124,12 @@ extern unsigned long get_board_ddr_clk(unsigned long dummy); */ #define CONFIG_SYS_NAND_BASE 0xef800000 #define CONFIG_SYS_NAND_BASE2 0xef840000 /* Unused at this time */ +#define CONFIG_SYS_NAND_BASE_LIST {CONFIG_SYS_NAND_BASE, \ + CONFIG_SYS_NAND_BASE2} +#define CONFIG_SYS_MAX_NAND_DEVICE 2 +#define CONFIG_MTD_NAND_VERIFY_WRITE +#define CONFIG_SYS_NAND_QUIET_TEST /* 2nd NAND flash not always populated */ +#define CONFIG_NAND_FSL_ELBC /* * NOR flash configuration @@ -375,16 +381,17 @@ extern unsigned long get_board_ddr_clk(unsigned long dummy); #define CONFIG_CMD_DTT #define CONFIG_CMD_EEPROM #define CONFIG_CMD_ELF -#define CONFIG_CMD_SAVEENV #define CONFIG_CMD_FLASH #define CONFIG_CMD_I2C #define CONFIG_CMD_JFFS2 #define CONFIG_CMD_MII +#define CONFIG_CMD_NAND #define CONFIG_CMD_NET #define CONFIG_CMD_PCA953X #define CONFIG_CMD_PCA953X_INFO #define CONFIG_CMD_PCI #define CONFIG_CMD_PING +#define CONFIG_CMD_SAVEENV #define CONFIG_CMD_SNTP /*