From: Shaohui Xie Date: Tue, 22 Apr 2014 10:21:37 +0000 (+0800) Subject: powerpc/fman/memac: use default MDIO_HOLD value X-Git-Tag: v2014.07-rc2~18^2~22 X-Git-Url: https://git.sur5r.net/?a=commitdiff_plain;h=3a7ed5aa232da1d2836b5d3962e59e685307122e;p=u-boot powerpc/fman/memac: use default MDIO_HOLD value Current driver uses a Maximum value for MDIO_HOLD when doing 10G MDIO access, this is due to an errata A-006260 on T4 rev1.0 which is fixed on rev2.0, so remove the maximum value to use the default value for rev2.0. Signed-off-by: Shaohui Xie --- diff --git a/drivers/net/fm/memac_phy.c b/drivers/net/fm/memac_phy.c index 2f4bc11a6c..de9c0e9cd2 100644 --- a/drivers/net/fm/memac_phy.c +++ b/drivers/net/fm/memac_phy.c @@ -29,10 +29,8 @@ int memac_mdio_write(struct mii_dev *bus, int port_addr, int dev_addr, c45 = 0; /* clause 22 */ dev_addr = regnum & 0x1f; clrbits_be32(®s->mdio_stat, MDIO_STAT_ENC); - } else { + } else setbits_be32(®s->mdio_stat, MDIO_STAT_ENC); - setbits_be32(®s->mdio_stat, MDIO_STAT_HOLD_15_CLK); - } /* Wait till the bus is free */ while ((in_be32(®s->mdio_stat)) & MDIO_STAT_BSY) @@ -76,10 +74,8 @@ int memac_mdio_read(struct mii_dev *bus, int port_addr, int dev_addr, c45 = 0; /* clause 22 */ dev_addr = regnum & 0x1f; clrbits_be32(®s->mdio_stat, MDIO_STAT_ENC); - } else { + } else setbits_be32(®s->mdio_stat, MDIO_STAT_ENC); - setbits_be32(®s->mdio_stat, MDIO_STAT_HOLD_15_CLK); - } /* Wait till the bus is free */ while ((in_be32(®s->mdio_stat)) & MDIO_STAT_BSY)