From: Mike Frysinger Date: Wed, 5 May 2010 04:56:30 +0000 (-0400) Subject: Blackfin: bfin_spi: add optional DMA support X-Git-Tag: v2010.12-rc1~169^2~34 X-Git-Url: https://git.sur5r.net/?a=commitdiff_plain;h=6f070e1867f5c31df17571b0c26f0a73cc3fe600;p=u-boot Blackfin: bfin_spi: add optional DMA support This moves the last piece from the old spi_flash driver to the new SPI framework -- optional DMA RX support. This typically cuts speeds by ~40% at the cost of additional ~300 bytes. Signed-off-by: Mike Frysinger --- diff --git a/arch/blackfin/include/asm/dma.h b/arch/blackfin/include/asm/dma.h new file mode 100644 index 0000000000..21ff1cf9fb --- /dev/null +++ b/arch/blackfin/include/asm/dma.h @@ -0,0 +1,75 @@ +/* + * dma.h - Blackfin DMA defines/structures/etc... + * + * Copyright 2004-2008 Analog Devices Inc. + * Licensed under the GPL-2 or later. + */ + +#ifndef _BLACKFIN_DMA_H_ +#define _BLACKFIN_DMA_H_ + +#include + +struct dmasg_large { + void *next_desc_addr; + unsigned long start_addr; + unsigned short cfg; + unsigned short x_count; + short x_modify; + unsigned short y_count; + short y_modify; +} __attribute__((packed)); + +struct dmasg { + unsigned long start_addr; + unsigned short cfg; + unsigned short x_count; + short x_modify; + unsigned short y_count; + short y_modify; +} __attribute__((packed)); + +struct dma_register { + void *next_desc_ptr; /* DMA Next Descriptor Pointer register */ + unsigned long start_addr; /* DMA Start address register */ + + unsigned short cfg; /* DMA Configuration register */ + unsigned short dummy1; /* DMA Configuration register */ + + unsigned long reserved; + + unsigned short x_count; /* DMA x_count register */ + unsigned short dummy2; + + short x_modify; /* DMA x_modify register */ + unsigned short dummy3; + + unsigned short y_count; /* DMA y_count register */ + unsigned short dummy4; + + short y_modify; /* DMA y_modify register */ + unsigned short dummy5; + + void *curr_desc_ptr; /* DMA Current Descriptor Pointer + register */ + unsigned long curr_addr_ptr; /* DMA Current Address Pointer + register */ + unsigned short irq_status; /* DMA irq status register */ + unsigned short dummy6; + + unsigned short peripheral_map; /* DMA peripheral map register */ + unsigned short dummy7; + + unsigned short curr_x_count; /* DMA Current x-count register */ + unsigned short dummy8; + + unsigned long reserved2; + + unsigned short curr_y_count; /* DMA Current y-count register */ + unsigned short dummy9; + + unsigned long reserved3; + +}; + +#endif diff --git a/drivers/spi/bfin_spi.c b/drivers/spi/bfin_spi.c index 556b97a64d..d7e14749dd 100644 --- a/drivers/spi/bfin_spi.c +++ b/drivers/spi/bfin_spi.c @@ -1,7 +1,7 @@ /* * Driver for Blackfin On-Chip SPI device * - * Copyright (c) 2005-2008 Analog Devices Inc. + * Copyright (c) 2005-2010 Analog Devices Inc. * * Licensed under the GPL-2 or later. */ @@ -13,6 +13,7 @@ #include #include +#include #include #include #include @@ -237,10 +238,131 @@ void spi_release_bus(struct spi_slave *slave) SSYNC(); } +#ifdef __ADSPBF54x__ +# define SPI_DMA_BASE DMA4_NEXT_DESC_PTR +#elif defined(__ADSPBF533__) || defined(__ADSPBF532__) || defined(__ADSPBF531__) || \ + defined(__ADSPBF538__) || defined(__ADSPBF539__) +# define SPI_DMA_BASE DMA5_NEXT_DESC_PTR +#elif defined(__ADSPBF561__) +# define SPI_DMA_BASE DMA2_4_NEXT_DESC_PTR +#elif defined(__ADSPBF537__) || defined(__ADSPBF536__) || defined(__ADSPBF534__) || \ + defined(__ADSPBF52x__) || defined(__ADSPBF51x__) +# define SPI_DMA_BASE DMA7_NEXT_DESC_PTR +#else +# error "Please provide SPI DMA channel defines" +#endif +static volatile struct dma_register *dma = (void *)SPI_DMA_BASE; + #ifndef CONFIG_BFIN_SPI_IDLE_VAL # define CONFIG_BFIN_SPI_IDLE_VAL 0xff #endif +#ifdef CONFIG_BFIN_SPI_NO_DMA +# define SPI_DMA 0 +#else +# define SPI_DMA 1 +#endif + +static int spi_dma_xfer(struct bfin_spi_slave *bss, const u8 *tx, u8 *rx, + uint bytes) +{ + int ret = -1; + u16 ndsize, spi_config, dma_config; + struct dmasg dmasg[2]; + const u8 *buf; + + if (tx) { + debug("%s: doing half duplex TX\n", __func__); + buf = tx; + spi_config = TDBR_DMA; + dma_config = 0; + } else { + debug("%s: doing half duplex RX\n", __func__); + buf = rx; + spi_config = RDBR_DMA; + dma_config = WNR; + } + + dmasg[0].start_addr = (unsigned long)buf; + dmasg[0].x_modify = 1; + dma_config |= WDSIZE_8 | DMAEN; + if (bytes <= 65536) { + blackfin_dcache_flush_invalidate_range(buf, buf + bytes); + ndsize = NDSIZE_5; + dmasg[0].cfg = NDSIZE_0 | dma_config | FLOW_STOP | DI_EN; + dmasg[0].x_count = bytes; + } else { + blackfin_dcache_flush_invalidate_range(buf, buf + 65536 - 1); + ndsize = NDSIZE_7; + dmasg[0].cfg = NDSIZE_5 | dma_config | FLOW_ARRAY | DMA2D; + dmasg[0].x_count = 0; /* 2^16 */ + dmasg[0].y_count = bytes >> 16; /* count / 2^16 */ + dmasg[0].y_modify = 1; + dmasg[1].start_addr = (unsigned long)(buf + (bytes & ~0xFFFF)); + dmasg[1].cfg = NDSIZE_0 | dma_config | FLOW_STOP | DI_EN; + dmasg[1].x_count = bytes & 0xFFFF; /* count % 2^16 */ + dmasg[1].x_modify = 1; + } + + dma->cfg = 0; + dma->irq_status = DMA_DONE | DMA_ERR; + dma->curr_desc_ptr = dmasg; + write_SPI_CTL(bss, (bss->ctl & ~TDBR_CORE)); + write_SPI_STAT(bss, -1); + SSYNC(); + + write_SPI_TDBR(bss, CONFIG_BFIN_SPI_IDLE_VAL); + dma->cfg = ndsize | FLOW_ARRAY | DMAEN; + write_SPI_CTL(bss, (bss->ctl & ~TDBR_CORE) | spi_config); + SSYNC(); + + /* + * We already invalidated the first 64k, + * now while we just wait invalidate the remaining part. + * Its not likely that the DMA is going to overtake + */ + if (bytes > 65536) + blackfin_dcache_flush_invalidate_range(buf + 65536, buf + bytes); + + while (!(dma->irq_status & DMA_DONE)) + if (ctrlc()) + goto done; + + dma->cfg = 0; + + ret = 0; + done: + write_SPI_CTL(bss, bss->ctl); + return ret; +} + +static int spi_pio_xfer(struct bfin_spi_slave *bss, const u8 *tx, u8 *rx, + uint bytes) +{ + /* todo: take advantage of hardware fifos */ + while (bytes--) { + u8 value = (tx ? *tx++ : CONFIG_BFIN_SPI_IDLE_VAL); + debug("%s: tx:%x ", __func__, value); + write_SPI_TDBR(bss, value); + SSYNC(); + while ((read_SPI_STAT(bss) & TXS)) + if (ctrlc()) + return -1; + while (!(read_SPI_STAT(bss) & SPIF)) + if (ctrlc()) + return -1; + while (!(read_SPI_STAT(bss) & RXS)) + if (ctrlc()) + return -1; + value = read_SPI_RDBR(bss); + if (rx) + *rx++ = value; + debug("rx:%x\n", value); + } + + return 0; +} + int spi_xfer(struct spi_slave *slave, unsigned int bitlen, const void *dout, void *din, unsigned long flags) { @@ -265,32 +387,11 @@ int spi_xfer(struct spi_slave *slave, unsigned int bitlen, const void *dout, if (flags & SPI_XFER_BEGIN) spi_cs_activate(slave); - /* todo: take advantage of hardware fifos and setup RX dma */ - while (bytes--) { - u8 value = (tx ? *tx++ : CONFIG_BFIN_SPI_IDLE_VAL); - debug("%s: tx:%x ", __func__, value); - write_SPI_TDBR(bss, value); - SSYNC(); - while ((read_SPI_STAT(bss) & TXS)) - if (ctrlc()) { - ret = -1; - goto done; - } - while (!(read_SPI_STAT(bss) & SPIF)) - if (ctrlc()) { - ret = -1; - goto done; - } - while (!(read_SPI_STAT(bss) & RXS)) - if (ctrlc()) { - ret = -1; - goto done; - } - value = read_SPI_RDBR(bss); - if (rx) - *rx++ = value; - debug("rx:%x\n", value); - } + /* TX DMA doesn't work quite right */ + if (SPI_DMA && bytes > 6 && (!tx /*|| !rx*/)) + ret = spi_dma_xfer(bss, tx, rx, bytes); + else + ret = spi_pio_xfer(bss, tx, rx, bytes); done: if (flags & SPI_XFER_END)