From: Sriram Dash <sriram.dash@nxp.com>
Date: Mon, 3 Oct 2016 10:54:46 +0000 (+0530)
Subject: armv8: fsl: Enable USB only when SYSCLK is 100 MHz
X-Git-Tag: v2016.11-rc2~16^2~14
X-Git-Url: https://git.sur5r.net/?a=commitdiff_plain;h=c93db4f763bc3ba7885c7431a4f3f946a5f5eecd;p=u-boot

armv8: fsl: Enable USB only when SYSCLK is 100 MHz

SYSCLK is used as a reference clock for USB. When the USB controller
is used, SYSCLK must meet the additional requirement of 100 MHz.

Signed-off-by: Sriram Dash <sriram.dash@nxp.com>
Reviewed-by: York Sun <york.sun@nxp.com>
---

diff --git a/arch/arm/cpu/armv8/fsl-layerscape/fdt.c b/arch/arm/cpu/armv8/fsl-layerscape/fdt.c
index 40d6a761e8..1a8321b0e4 100644
--- a/arch/arm/cpu/armv8/fsl-layerscape/fdt.c
+++ b/arch/arm/cpu/armv8/fsl-layerscape/fdt.c
@@ -108,6 +108,24 @@ remove_psci_node:
 }
 #endif
 
+void fsl_fdt_disable_usb(void *blob)
+{
+	int off;
+	/*
+	 * SYSCLK is used as a reference clock for USB. When the USB
+	 * controller is used, SYSCLK must meet the additional requirement
+	 * of 100 MHz.
+	 */
+	if (CONFIG_SYS_CLK_FREQ != 100000000) {
+		off = fdt_node_offset_by_compatible(blob, -1, "snps,dwc3");
+		while (off != -FDT_ERR_NOTFOUND) {
+			fdt_status_disabled(blob, off);
+			off = fdt_node_offset_by_compatible(blob, off,
+							    "snps,dwc3");
+		}
+	}
+}
+
 void ft_cpu_setup(void *blob, bd_t *bd)
 {
 #ifdef CONFIG_FSL_LSCH2
@@ -150,4 +168,6 @@ void ft_cpu_setup(void *blob, bd_t *bd)
 #ifdef CONFIG_SYS_DPAA_FMAN
 	fdt_fixup_fman_firmware(blob);
 #endif
+	fsl_fdt_disable_usb(blob);
+
 }