From 02a32a92d4a123c75292a284bdc605c376d204f7 Mon Sep 17 00:00:00 2001 From: Soeren Moch Date: Thu, 20 Nov 2014 13:03:32 +0100 Subject: [PATCH] tbs2910: Fix error handling in board_mmc_init() When an invalid USDHC port is passed we should return -EINVAL instead of 0. Also, return the error immediately on fsl_esdhc_initialize() failure. Based on similar patches by Fabio Estevam for mx6sabresd, mx53loco, wandboard Signed-off-by: Soeren Moch Acked-by: Stefano Babic --- board/tbs/tbs2910/tbs2910.c | 13 ++++++------- 1 file changed, 6 insertions(+), 7 deletions(-) diff --git a/board/tbs/tbs2910/tbs2910.c b/board/tbs/tbs2910/tbs2910.c index daf8ff4e62..dfa430e4ab 100644 --- a/board/tbs/tbs2910/tbs2910.c +++ b/board/tbs/tbs2910/tbs2910.c @@ -219,15 +219,13 @@ int board_mmc_getcd(struct mmc *mmc) int board_mmc_init(bd_t *bis) { - s32 status = 0; - int i; - /* * (U-boot device node) (Physical Port) * mmc0 SD2 * mmc1 SD3 * mmc2 eMMC */ + int i, ret; for (i = 0; i < CONFIG_SYS_FSL_USDHC_NUM; i++) { switch (i) { case 0: @@ -251,12 +249,13 @@ int board_mmc_init(bd_t *bis) printf("Warning: you configured more USDHC controllers" "(%d) then supported by the board (%d)\n", i + 1, CONFIG_SYS_FSL_USDHC_NUM); - return status; + return -EINVAL; } - - status |= fsl_esdhc_initialize(bis, &usdhc_cfg[i]); + ret = fsl_esdhc_initialize(bis, &usdhc_cfg[i]); + if (ret) + return ret; } - return status; + return 0; } #endif /* CONFIG_FSL_ESDHC */ -- 2.39.5