From 1748aab2c9202783a723f6d58a204a57f1094663 Mon Sep 17 00:00:00 2001 From: Uwe Hermann Date: Mon, 2 Apr 2012 00:25:37 +0200 Subject: [PATCH] Initial config for the Voltcraft DSO-3062C. This is a digital oscilloscope which uses a Samsung S3C2440 internally. http://randomprojects.org/wiki/Voltcraft_DSO-3062C Signed-off-by: Uwe Hermann Change-Id: I5e28c3a8f30665a162e34c831294e4e658a16ebb Reviewed-on: http://openocd.zylin.com/548 Tested-by: jenkins Reviewed-by: Peter Stuge --- tcl/board/voltcraft_dso-3062c.cfg | 31 +++++++++++++++++++++++++++++++ 1 file changed, 31 insertions(+) create mode 100644 tcl/board/voltcraft_dso-3062c.cfg diff --git a/tcl/board/voltcraft_dso-3062c.cfg b/tcl/board/voltcraft_dso-3062c.cfg new file mode 100644 index 00000000..01e37e9a --- /dev/null +++ b/tcl/board/voltcraft_dso-3062c.cfg @@ -0,0 +1,31 @@ +# +# Voltcraft DSO-3062C digital oscilloscope (uses a Samsung S3C2440) +# +# http://www.eevblog.com/forum/general-chat/hantek-tekway-dso-hack-get-200mhz-bw-for-free/ +# http://www.mikrocontroller.net/topic/249628 +# http://elinux.org/Das_Oszi +# http://randomprojects.org/wiki/Voltcraft_DSO-3062C +# + +# Enable this if your JTAG adapter supports multiple transports (JTAG or SWD). +# Otherwise comment it out, as it will cause an OpenOCD error. +### transport select jtag + +source [find target/samsung_s3c2440.cfg] + +adapter_khz 16000 + +# Samsung K9F1208U0C NAND flash chip (64MiB, 3.3V, 8-bit) +nand device $_CHIPNAME.nand s3c2440 $_TARGETNAME + +# arm7_9 fast_memory_access enable +# arm7_9 dcc_downloads enable + +init +reset +halt +scan_chain +targets +nand probe 0 +nand list + -- 2.39.5