From 25d7ba19c9e70cf5b912f660cf6aaa93d9ca120f Mon Sep 17 00:00:00 2001 From: Tomas Vanek Date: Wed, 24 Aug 2016 11:18:41 +0200 Subject: [PATCH] tcl at91samdXX.cfg: update config to current OpenOCD status Remove comment about workaround of not working 'reset halt' - not needed as 'reset halt' is working as expected @ EDBG with srst_only. Add srst_pulls_trst to reset_config as it no more triggers an error. Change-Id: I47cf445690c46ccfb866900cddbfcaefc8649f82 Signed-off-by: Tomas Vanek Reviewed-on: http://openocd.zylin.com/3722 Tested-by: jenkins Reviewed-by: Andreas Fritiofson --- tcl/target/at91samdXX.cfg | 8 +------- 1 file changed, 1 insertion(+), 7 deletions(-) diff --git a/tcl/target/at91samdXX.cfg b/tcl/target/at91samdXX.cfg index 47b4f5f1..9a3c2928 100644 --- a/tcl/target/at91samdXX.cfg +++ b/tcl/target/at91samdXX.cfg @@ -50,13 +50,7 @@ $_TARGETNAME configure -event reset-deassert-post { } # SRST (wired to RESET_N) resets debug circuitry -# srst_pulls_trst is not configured here to avoid an error raised in reset halt -reset_config srst_gates_jtag - -# Atmel's EDBG (on-board cmsis-dap adapter of Xplained kits) cannot -# stop the MCU before it starts executing code if hardware RESETN -# line is configured by command "reset_config srst_only" -# Use "reset_config none" (default) before flash programming. +reset_config srst_gates_jtag srst_pulls_trst # Do not use a reset button with other SWD adapter than Atmel's EDBG. # DSU usually locks MCU in reset state until you issue a reset command -- 2.39.5