From 2df810717e8737b9c4a7d2a93b0100fcd7eae84f Mon Sep 17 00:00:00 2001 From: Vikas Manocha Date: Fri, 21 Nov 2014 10:34:20 -0800 Subject: [PATCH] serial: pl01x: fix pl011 baud rate configuration UART_IBRD, UART_FBRD, and UART_LCR_H form a single 30-bit wide register which is updated on a single write strobe generated by a UART_LCR_H write. So, to internally update the content of UART_IBRD or UART_FBRD, a write to UART_LCR_H must always be performed at the end. Signed-off-by: Vikas Manocha Acked-by: Simon Glass --- drivers/serial/serial_pl01x.c | 8 ++++++++ 1 file changed, 8 insertions(+) diff --git a/drivers/serial/serial_pl01x.c b/drivers/serial/serial_pl01x.c index 1860289ce4..a58ad8ab36 100644 --- a/drivers/serial/serial_pl01x.c +++ b/drivers/serial/serial_pl01x.c @@ -122,6 +122,7 @@ static int pl01x_generic_serial_init(struct pl01x_regs *regs, static int pl01x_generic_setbrg(struct pl01x_regs *regs, enum pl01x_type type, int clock, int baudrate) { + unsigned int lcr; switch (type) { case TYPE_PL010: { unsigned int divisor; @@ -175,6 +176,13 @@ static int pl01x_generic_setbrg(struct pl01x_regs *regs, enum pl01x_type type, writel(divider, ®s->pl011_ibrd); writel(fraction, ®s->pl011_fbrd); + /* + * Internal update of baud rate register require line + * control register write + */ + lcr = UART_PL011_LCRH_WLEN_8 | UART_PL011_LCRH_FEN; + writel(lcr, ®s->pl011_lcrh); + /* Finally, enable the UART */ writel(UART_PL011_CR_UARTEN | UART_PL011_CR_TXE | UART_PL011_CR_RXE | UART_PL011_CR_RTS, ®s->pl011_cr); -- 2.39.5