From 7da3c2cda246f010462ac25776651bc5b6163b51 Mon Sep 17 00:00:00 2001 From: zwelch Date: Mon, 1 Jun 2009 23:06:17 +0000 Subject: [PATCH] David Brownell : This is the missing half of the r1974 patch: OSK5912 board support, which was split out from the omap5912 target config. git-svn-id: svn://svn.berlios.de/openocd/trunk@1985 b42882b7-edfa-0310-969c-e2dbd0fdcd60 --- tcl/board/osk5912.cfg | 28 ++++++++++++++++++++++++++++ 1 file changed, 28 insertions(+) create mode 100644 tcl/board/osk5912.cfg diff --git a/tcl/board/osk5912.cfg b/tcl/board/osk5912.cfg new file mode 100644 index 00000000..e189d076 --- /dev/null +++ b/tcl/board/osk5912.cfg @@ -0,0 +1,28 @@ +# http://omap.spectrumdigital.com/osk5912/ + +source [find target/omap5912.cfg] + +# NOTE: this assumes you're using the ARM 20-pin ("Multi-ICE") +# JTAG connector, and accordingly have J1 connecting pins 1 & 2. +# The TI-14 pin needs "trst_only", and J1 connecting 2 & 3. +reset_config trst_and_srst separate + +# NOTE: an expansion board could add a trace connector ... if +# it does, change this appropriately. And reset_config too, +# assuming JTAG_DIS reroutes JTAG to that connector. +etm config $_TARGETNAME 8 demultiplexed full dummy +etm_dummy config $_TARGETNAME + +# standard boards populate two 16 MB chips, but manufacturing +# options or an expansion board could change this config. +flash bank cfi 0x00000000 0x01000000 2 2 $_TARGETNAME +flash bank cfi 0x01000000 0x01000000 2 2 $_TARGETNAME + +proc osk5912_init {} { + omap5912_reset + + # detect flash + flash probe 0 + flash probe 1 +} +$_TARGETNAME configure -event reset-init { osk5912_init } -- 2.39.5