From 87610a41790f3568720701008259c859e2d01ae2 Mon Sep 17 00:00:00 2001 From: Oleksij Rempel Date: Wed, 31 Jan 2018 11:58:50 +0100 Subject: [PATCH] tcl/board: add config for 8devices LIMA board More information about this board can be found here: https://www.8devices.com/products/lima Change-Id: Id35a35d3e986630d58d37b47828870afd107cc6a Signed-off-by: Oleksij Rempel Reviewed-on: http://openocd.zylin.com/4406 Tested-by: jenkins Reviewed-by: Paul Fertser --- tcl/board/8devices-lima.cfg | 30 ++++++++++++++++++++++++++++++ 1 file changed, 30 insertions(+) create mode 100644 tcl/board/8devices-lima.cfg diff --git a/tcl/board/8devices-lima.cfg b/tcl/board/8devices-lima.cfg new file mode 100644 index 00000000..136f8619 --- /dev/null +++ b/tcl/board/8devices-lima.cfg @@ -0,0 +1,30 @@ +# Product page: +# https://www.8devices.com/products/lima +# +# Location of JTAG pins: +# J2 GPIO0 JTAG TCK +# J2 GPIO1 JTAG TDI +# J2 GPIO2 JTAG TDO +# J2 GPIO3 JTAG TMS +# J2 RST directly connected to RESET_L of the SoC and can be used as +# JTAG SRST. Note: this pin will also reset the debug engine. +# J1 +3,3V Can be use as JTAG Vref +# J1 or J2 GND Can be used for JTAG GND +# +# This board is powered from mini USB connecter which is also used +# as USB to UART converted based on FTDI FT230XQ chip + +source [find target/qualcomm_qca4531.cfg] + +proc board_init { } { + qca4531_ddr2_550_550_init +} + +$_TARGETNAME configure -event reset-init { + board_init +} + +set ram_boot_address 0xa0000000 +$_TARGETNAME configure -work-area-phys 0xa1FFE000 -work-area-size 0x1000 + +flash bank flash0 ath79 0 0 0 0 $_TARGETNAME cs0 -- 2.39.5