From a3ed9789e73c2de1b0c1d52b9c0d2674147f3b9a Mon Sep 17 00:00:00 2001 From: Stefan Roese Date: Tue, 11 Aug 2015 17:08:01 +0200 Subject: [PATCH] arm: mvebu: sdram: Enable ECC support on Armada XP This is tested on the DB-MV784MP-GP eval board. To really enable ECC support on this board the I2C EEPROM needs to get changed. As it saves the enabling of ECC support internally. For this the following commands can be used to enable ECC support on this board: Its recommended for first save (print) the value(s) in this EEPROM address: => i2c md 4e 0.1 2 0000: 05 00 .. To enable ECC support you need to set bit 1 in the 2nd byte: Marvell>> i2c mw 4e 1.1 02 Marvell>> i2c md 4e 0.1 2 0000: 05 02 .. To disable ECC support again, please use this command: Marvell>> i2c mw 4e 1.1 00 Marvell>> i2c md 4e 0.1 2 0000: 05 00 .. On other AXP boards, simply plugging an ECC DIMM should be enough to enable ECC support. Signed-off-by: Stefan Roese Cc: Luka Perkov --- drivers/ddr/marvell/axp/ddr3_axp_config.h | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/ddr/marvell/axp/ddr3_axp_config.h b/drivers/ddr/marvell/axp/ddr3_axp_config.h index 800d2d1476..a6720442ff 100644 --- a/drivers/ddr/marvell/axp/ddr3_axp_config.h +++ b/drivers/ddr/marvell/axp/ddr3_axp_config.h @@ -44,7 +44,7 @@ * DDR3_TRAINING_DEBUG - Debug prints of internal code */ #define DDR_TARGET_FABRIC 5 -#define DRAM_ECC 0 +#define DRAM_ECC 1 #ifdef MV_DDR_32BIT #define BUS_WIDTH 32 -- 2.39.5