From ab584d67c5a7c2349685274a711b579c28d5aaaf Mon Sep 17 00:00:00 2001 From: Holger Freyther Date: Mon, 4 Aug 2014 09:26:05 +0200 Subject: [PATCH] The _config target is not present anymore, mention _defconfig instead The _config part is gone for sure, the _defconfig target could at least work. I have not verified this for all targets though. --- README | 22 +++++++++++----------- 1 file changed, 11 insertions(+), 11 deletions(-) diff --git a/README b/README index 0d295a718e..1d713596ec 100644 --- a/README +++ b/README @@ -252,15 +252,15 @@ Selection of Processor Architecture and Board Type: --------------------------------------------------- For all supported boards there are ready-to-use default -configurations available; just type "make _config". +configurations available; just type "make _defconfig". Example: For a TQM823L module type: cd u-boot - make TQM823L_config + make TQM823L_defconfig For the Cogent platform, you need to specify the CPU type as well; -e.g. "make cogent_mpc8xx_config". And also configure the cogent +e.g. "make cogent_mpc8xx_defconfig". And also configure the cogent directory according to the instructions in cogent/README. @@ -4847,9 +4847,9 @@ U-Boot is intended to be simple to build. After installing the sources you must configure U-Boot for one specific board type. This is done by typing: - make NAME_config + make NAME_defconfig -where "NAME_config" is the name of one of the existing configu- +where "NAME_defconfig" is the name of one of the existing configu- rations; see boards.cfg for supported names. Note: for some board special configuration names may exist; check if @@ -4858,10 +4858,10 @@ Note: for some board special configuration names may exist; check if or with LCD support. You can select such additional "features" when choosing the configuration, i. e. - make TQM823L_config + make TQM823L_defconfig - will configure for a plain TQM823L, i. e. no LCD support - make TQM823L_LCD_config + make TQM823L_LCD_defconfig - will configure for a TQM823L with U-Boot console on LCD etc. @@ -4881,14 +4881,14 @@ this behavior and build U-Boot to some external directory: 1. Add O= to the make command line invocations: make O=/tmp/build distclean - make O=/tmp/build NAME_config + make O=/tmp/build NAME_defconfig make O=/tmp/build all 2. Set environment variable BUILD_DIR to point to the desired location: export BUILD_DIR=/tmp/build make distclean - make NAME_config + make NAME_defconfig make all Note that the command line "O=" setting overrides the BUILD_DIR environment @@ -4914,7 +4914,7 @@ steps: your board 3. If you're porting U-Boot to a new CPU, then also create a new directory to hold your CPU specific code. Add any files you need. -4. Run "make _config" with your new name. +4. Run "make _defconfig" with your new name. 5. Type "make", and you should get a working "u-boot.srec" file to be installed on your target system. 6. Debug and solve any problems that might arise. @@ -5494,7 +5494,7 @@ which was introduced for our predecessor project PPCBoot and uses a Example: - make TQM850L_config + make TQM850L_defconfig make oldconfig make dep make uImage -- 2.39.5