From ecd7b246f69640dfe8e28a5c78f245b8a43a4435 Mon Sep 17 00:00:00 2001 From: Jaehoon Chung Date: Fri, 30 Dec 2016 15:30:11 +0900 Subject: [PATCH] mmc: sdhci: disable the 8bit mode when host doesn't support it Buswidth is depeneded on Hardware schematic. Evne though host can support the 8bit buswidth, if hardware doesn't support 8bit mode, it doesn't work fine. So the buswidth mode selection leaves a matter in each SoC drivers. On the contrary to this, hardware supports 8bit mode, but host doesn't support it. then controller has to disable the MMC_MODE_8BIT. (Host can check whether 8bit mode is supported or not, since V3.0) Signed-off-by: Jaehoon Chung --- drivers/mmc/sdhci.c | 5 ++--- 1 file changed, 2 insertions(+), 3 deletions(-) diff --git a/drivers/mmc/sdhci.c b/drivers/mmc/sdhci.c index cbf5f56221..853c268d72 100644 --- a/drivers/mmc/sdhci.c +++ b/drivers/mmc/sdhci.c @@ -594,14 +594,13 @@ int sdhci_setup_cfg(struct mmc_config *cfg, struct sdhci_host *host, cfg->host_caps = MMC_MODE_HS | MMC_MODE_HS_52MHz | MMC_MODE_4BIT; if (SDHCI_GET_VERSION(host) >= SDHCI_SPEC_300) { - if (caps & SDHCI_CAN_DO_8BIT) - cfg->host_caps |= MMC_MODE_8BIT; + if (!(caps & SDHCI_CAN_DO_8BIT)) + cfg->host_caps &= ~MMC_MODE_8BIT; } if (host->host_caps) cfg->host_caps |= host->host_caps; - cfg->b_max = CONFIG_SYS_MMC_MAX_BLK_COUNT; /* -- 2.39.5