From f17ea71d3a8c44c9a74ab1df1eca43b9755cb225 Mon Sep 17 00:00:00 2001 From: Michal Simek Date: Tue, 8 Sep 2015 17:20:01 +0200 Subject: [PATCH] net: zynq: Change MDC setup for arm64 MDC setting depends on pclk input clocks which varies across SoC. This driver is used by xilinx zynq and zynqmp SOC. Input clock frequence on silicon is 125MHz where divider 64 put frequency below 2.5MHz requires by spec (125/64=1.95). Signed-off-by: Michal Simek --- drivers/net/zynq_gem.c | 4 ++++ 1 file changed, 4 insertions(+) diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c index 97e30f3be0..b3821c31a9 100644 --- a/drivers/net/zynq_gem.c +++ b/drivers/net/zynq_gem.c @@ -57,7 +57,11 @@ DECLARE_GLOBAL_DATA_PTR; #define ZYNQ_GEM_NWCFG_SPEED1000 0x000000400 /* 1Gbps operation */ #define ZYNQ_GEM_NWCFG_FDEN 0x000000002 /* Full Duplex mode */ #define ZYNQ_GEM_NWCFG_FSREM 0x000020000 /* FCS removal */ +#ifdef CONFIG_ARM64 +#define ZYNQ_GEM_NWCFG_MDCCLKDIV 0x000100000 /* Div pclk by 64, max 160MHz */ +#else #define ZYNQ_GEM_NWCFG_MDCCLKDIV 0x0000c0000 /* Div pclk by 48, max 120MHz */ +#endif #ifdef CONFIG_ARM64 # define ZYNQ_GEM_DBUS_WIDTH (1 << 21) /* 64 bit bus */ -- 2.39.5