From f221db0ed5b4c6580abb4ab6fde5cbabaa348350 Mon Sep 17 00:00:00 2001 From: Steve Rae Date: Tue, 7 Jun 2016 15:35:21 -0700 Subject: [PATCH] usb: dwc2_udc_otg: support 8-bit interface Define CONFIG_USB_GADGET_DWC2_OTG_PHY_BUS_WIDTH_8 to allow the physical interface to be 8-bit (rather than 16-bit). Signed-off-by: Steve Rae --- drivers/usb/gadget/Kconfig | 10 ++++++++++ drivers/usb/gadget/dwc2_udc_otg.c | 4 ++++ 2 files changed, 14 insertions(+) diff --git a/drivers/usb/gadget/Kconfig b/drivers/usb/gadget/Kconfig index a35a1c7760..ae624766c1 100644 --- a/drivers/usb/gadget/Kconfig +++ b/drivers/usb/gadget/Kconfig @@ -52,6 +52,16 @@ config USB_GADGET_DWC2_OTG driver to operate in Peripheral mode. This option requires USB_GADGET to be enabled. +if USB_GADGET_DWC2_OTG + +config USB_GADGET_DWC2_OTG_PHY_BUS_WIDTH_8 + bool "DesignWare USB2.0 HS OTG controller 8-bit PHY bus width" + help + Set the Designware USB2.0 high-speed OTG controller + PHY interface width to 8 bits, rather than the default (16 bits). + +endif # USB_GADGET_DWC2_OTG + config CI_UDC bool "ChipIdea device controller" select USB_GADGET_DUALSPEED diff --git a/drivers/usb/gadget/dwc2_udc_otg.c b/drivers/usb/gadget/dwc2_udc_otg.c index cb20b00a56..a23278d957 100644 --- a/drivers/usb/gadget/dwc2_udc_otg.c +++ b/drivers/usb/gadget/dwc2_udc_otg.c @@ -415,7 +415,11 @@ static void reconfig_usbd(struct dwc2_udc *dev) |0<<7 /* Ulpi DDR sel*/ |0<<6 /* 0: high speed utmi+, 1: full speed serial*/ |0<<4 /* 0: utmi+, 1:ulpi*/ +#ifdef CONFIG_USB_GADGET_DWC2_OTG_PHY_BUS_WIDTH_8 + |0<<3 /* phy i/f 0:8bit, 1:16bit*/ +#else |1<<3 /* phy i/f 0:8bit, 1:16bit*/ +#endif |0x7<<0; /* HS/FS Timeout**/ if (dev->pdata->usb_gusbcfg) -- 2.39.5