1 How to use U-Boot on Engicam i.CoreM6 DualLite/Solo and Quad/Dual Starter Kit:
2 -----------------------------------------------------------------------------
4 - Build U-Boot for Engicam i.CoreM6 QDL:
7 $ make icorem6qdl_mmc_defconfig
10 This will generate the SPL image called SPL and the u-boot.img.
12 - Flash the SPL image into the micro SD card:
14 sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
16 - Flash the u-boot.img image into the micro SD card:
18 sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync
24 - Connect the Serial cable between the Starter Kit and the PC for the console.
25 (J28 is the Linux Serial console connector)
27 - Insert the micro SD card in the board, power it up and U-Boot messages should
30 - Note: For loading Linux on Quad/Dual modules set the dtb as
31 icorem6qdl> setenv fdt_file imx6q-icore.dtb