1 Hsow to use U-Boot on Engicam i.CoreM6 (RQS) Solo/DualLite/Quad/Dual Starter Kit:
2 --------------------------------------------------------------------------------
6 - Configure U-Boot for Engicam i.CoreM6 Quad/Duali/Solo/DualLite:
7 $ make imx6qdl_icore_mmc_defconfig
9 - Configure U-Boot for Engicam i.CoreM6 RQS Quad/Duali/Solo/DualLite:
10 $ make imx6qdl_icore_rqs_defconfig
15 This will generate the SPL image called SPL and the u-boot-dtb.img.
17 - Flash the SPL image into the micro SD card:
19 sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
21 - Flash the u-boot-dtb.img image into the micro SD card:
23 sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync
29 - Connect the Serial cable between the Starter Kit and the PC for the console.
30 (J28 is the Linux Serial console connector)
32 - Insert the micro SD card in the board, power it up and U-Boot messages should