1 How to use U-Boot on Freescale MX6UL 14x14 EVK
2 -----------------------------------------------
4 - Build U-Boot for MX6UL 14x14 EVK:
7 $ make mx6ul_14x14_evk_defconfig
10 This will generate the SPL image called SPL and the u-boot.img.
12 - Flash the SPL image into the micro SD card:
14 sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
16 - Flash the u-boot.img image into the micro SD card:
18 sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync
25 where 0 means bottom position and 1 means top position (from the
26 switch label numbers reference).
28 - Connect the USB cable between the EVK and the PC for the console.
29 (The USB console connector is the one close the push buttons)
31 - Insert the micro SD card in the board, power it up and U-Boot messages should