4 This file contains information for the port of U-Boot to the Wandboard.
6 Wandboard is a development board that has three variants based on the following
7 SoCs: mx6 quad, mx6 dual lite and mx6 solo.
9 For more details about Wandboard, please refer to:
10 http://www.wandboard.org/
12 Building U-boot for Wandboard
13 -----------------------------
15 To build U-Boot for the Wandboard:
17 $ make wandboard_config
20 Flashing U-boot into the SD card
21 --------------------------------
23 - After the 'make' command completes, the generated 'SPL' binary must be
24 flashed into the SD card;
26 $ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
28 (Note - the SD card node may vary, so adjust this as needed).
30 - Flash the u-boot.img image into the SD card:
32 sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync
34 - Insert the SD card into the slot located in the bottom of the board (same side
37 - Connect the serial cable to the host PC
39 - Power up the board and U-boot messages will appear in the serial console.