4 This file contains information for the port of U-Boot to the Wandboard.
6 Wandboard is a development board that has two variants: one version based
7 on mx6 dual lite and another one based on mx6 solo.
9 For more details about Wandboard, please refer to:
10 http://www.wandboard.org/
12 Building U-boot for Wandboard
13 -----------------------------
15 To build U-Boot for the Wandboard Dual Lite version:
17 $ make wanboard_dl_config
20 To build U-Boot for the Wandboard Solo version:
22 $ make wanboard_solo_config
25 Flashing U-boot into the SD card
26 --------------------------------
28 - After the 'make' command completes, the generated 'u-boot.imx' binary must be
29 flashed into the SD card;
31 $ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=512 seek=2; sync
33 (Note - the SD card node may vary, so adjust this as needed).
35 - Insert the SD card into the slot located in the bottom of the board (same side
38 - Connect the serial cable to the host PC
40 - Power up the board and U-boot messages will appear in the serial console.