1 menu "NAND Device Support"
6 bool "Support Denali NAND controller"
8 Enable support for the Denali NAND controller.
10 config SYS_NAND_DENALI_64BIT
11 bool "Use 64-bit variant of Denali NAND controller"
12 depends on NAND_DENALI
14 The Denali NAND controller IP has some variations in terms of
15 the bus interface. The DMA setup sequence is completely differenct
16 between 32bit / 64bit AXI bus variants.
18 If your Denali NAND controller is the 64-bit variant, say Y.
19 Otherwise (32 bit), say N.
21 config NAND_DENALI_SPARE_AREA_SKIP_BYTES
22 int "Number of bytes skipped in OOB area"
23 depends on NAND_DENALI
26 This option specifies the number of bytes to skip from the beginning
27 of OOB area before last ECC sector data starts. This is potentially
28 used to preserve the bad block marker in the OOB area.
34 config SPL_NAND_DENALI
35 bool "Support Denali NAND controller for SPL"
37 This is a small implementation of the Denali NAND controller