]> git.sur5r.net Git - u-boot/blob - include/configs/10m50_devboard.h
arm: stm32mp1: add PSCI support
[u-boot] / include / configs / 10m50_devboard.h
1 /* SPDX-License-Identifier: GPL-2.0+ */
2 /*
3  * (C) Copyright 2005, Psyent Corporation <www.psyent.com>
4  * Scott McNutt <smcnutt@psyent.com>
5  * (C) Copyright 2010, Thomas Chou <thomas@wytron.com.tw>
6  */
7
8 #ifndef __CONFIG_H
9 #define __CONFIG_H
10
11 /*
12  * BOARD/CPU
13  */
14
15 /*
16  * SERIAL
17  */
18 #define CONFIG_SYS_NS16550_MEM32
19
20 /*
21  * Flash
22  */
23 #define CONFIG_SYS_MAX_FLASH_BANKS      1
24 #define CONFIG_SYS_MAX_FLASH_SECT       1024
25 #define CONFIG_MTD_DEVICE
26
27 /*
28  * NET options
29  */
30 #define CONFIG_SYS_RX_ETH_BUFFER        0
31 #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
32 #define CONFIG_PHY_MARVELL
33
34 /*
35  * BOOTP options
36  */
37 #define CONFIG_BOOTP_BOOTFILESIZE
38
39 /*
40  * FDT options
41  */
42 #define CONFIG_LMB
43
44 /*
45  * MEMORY ORGANIZATION
46  * -Monitor at top of sdram.
47  * -The heap is placed below the monitor
48  * -The stack is placed below the heap (&grows down).
49  */
50 #define CONFIG_SYS_SDRAM_BASE           0xc8000000
51 #define CONFIG_SYS_SDRAM_SIZE           0x08000000
52 #define CONFIG_NR_DRAM_BANKS            1
53 #define CONFIG_MONITOR_IS_IN_RAM
54 #define CONFIG_SYS_MONITOR_LEN          0x80000 /* Reserve 512k */
55 #define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_SDRAM_BASE + \
56                                          CONFIG_SYS_SDRAM_SIZE - \
57                                          CONFIG_SYS_MONITOR_LEN)
58 #define CONFIG_SYS_MALLOC_LEN           0x20000
59
60 /*
61  * ENVIRONMENT -- Put environment in sector CONFIG_SYS_MONITOR_LEN above
62  * CONFIG_SYS_RESET_ADDR, since we assume the monitor is stored at the
63  * reset address, no? This will keep the environment in user region
64  * of flash. NOTE: the monitor length must be multiple of sector size
65  * (which is common practice).
66  */
67
68 #define CONFIG_ENV_SIZE                 0x10000 /* 64k, 1 sector */
69 #define CONFIG_ENV_OVERWRITE            /* Serial change Ok     */
70 #define CONFIG_ENV_ADDR                 (0xf4000000 + CONFIG_SYS_MONITOR_LEN)
71
72 /*
73  * MISC
74  */
75 #define CONFIG_SYS_LOAD_ADDR            0xcc000000      /* Half of RAM */
76 #define CONFIG_LOADADDR                 CONFIG_SYS_LOAD_ADDR
77 #define CONFIG_SYS_MEMTEST_START        CONFIG_SYS_SDRAM_BASE
78 #define CONFIG_SYS_MEMTEST_END          (CONFIG_SYS_MONITOR_BASE - \
79                                          CONFIG_ENV_SIZE - \
80                                          CONFIG_SYS_MALLOC_LEN -        \
81                                          0x10000)
82
83 #endif /* __CONFIG_H */