2 * Copyright 2016 Freescale Semiconductor
4 * SPDX-License-Identifier: GPL-2.0+
7 #ifndef __LS1012A_COMMON_H
8 #define __LS1012A_COMMON_H
10 #define CONFIG_FSL_LAYERSCAPE
13 #include <asm/arch/config.h>
14 #include <asm/arch/stream_id_lsch2.h>
16 #define CONFIG_SYS_CLK_FREQ 125000000
18 #define CONFIG_SKIP_LOWLEVEL_INIT
20 #define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_FSL_OCRAM_BASE + 0xfff0)
21 #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000)
23 #define CONFIG_SYS_DDR_SDRAM_BASE 0x80000000
24 #define CONFIG_SYS_FSL_DDR_SDRAM_BASE_PHY 0
25 #define CONFIG_SYS_SDRAM_BASE CONFIG_SYS_DDR_SDRAM_BASE
26 #define CONFIG_SYS_DDR_BLOCK2_BASE 0x880000000ULL
28 /* Generic Timer Definitions */
29 #define COUNTER_FREQUENCY 25000000 /* 25MHz */
32 #define CONFIG_LAYERSCAPE_NS_ACCESS
34 /* Size of malloc() pool */
35 #define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128 * 1024)
38 #ifdef CONFIG_QSPI_BOOT
39 #define CONFIG_SYS_QE_FW_IN_SPIFLASH
40 #define CONFIG_SYS_FMAN_FW_ADDR 0x400d0000
41 #define CONFIG_ENV_SPI_BUS 0
42 #define CONFIG_ENV_SPI_CS 0
43 #define CONFIG_ENV_SPI_MAX_HZ 1000000
44 #define CONFIG_ENV_SPI_MODE 0x03
45 #define CONFIG_SPI_FLASH_SPANSION
46 #define CONFIG_FSL_SPI_INTERFACE
47 #define CONFIG_SF_DATAFLASH
49 #define CONFIG_FSL_QSPI
50 #define QSPI0_AMBA_BASE 0x40000000
51 #define CONFIG_SPI_FLASH_SPANSION
53 #define FSL_QSPI_FLASH_SIZE SZ_64M
54 #define FSL_QSPI_FLASH_NUM 2
59 #define CONFIG_ENV_OVERWRITE
61 #define CONFIG_ENV_SIZE 0x40000 /* 256KB */
62 #define CONFIG_ENV_OFFSET 0x300000 /* 3MB */
63 #define CONFIG_ENV_SECT_SIZE 0x40000
67 #define CONFIG_SCSI_AHCI_PLAT
69 #define CONFIG_SYS_SATA AHCI_BASE_ADDR
71 #define CONFIG_SYS_SCSI_MAX_SCSI_ID 1
72 #define CONFIG_SYS_SCSI_MAX_LUN 1
73 #define CONFIG_SYS_SCSI_MAX_DEVICE (CONFIG_SYS_SCSI_MAX_SCSI_ID * \
74 CONFIG_SYS_SCSI_MAX_LUN)
77 #define CONFIG_SYS_I2C
78 #define CONFIG_SYS_I2C_MXC
79 #define CONFIG_SYS_I2C_MXC_I2C1 /* enable I2C bus 1 */
80 #define CONFIG_SYS_I2C_MXC_I2C2 /* enable I2C bus 2 */
82 #define CONFIG_SYS_NS16550_SERIAL
83 #define CONFIG_SYS_NS16550_REG_SIZE 1
84 #define CONFIG_SYS_NS16550_CLK (get_serial_clock())
86 #define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
88 #define CONFIG_SYS_HZ 1000
90 #define CONFIG_HWCONFIG
91 #define HWCONFIG_BUFFER_SIZE 128
93 #ifndef CONFIG_SPL_BUILD
94 #define BOOT_TARGET_DEVICES(func) \
98 #include <config_distro_bootcmd.h>
101 /* Initial environment variables */
102 #define CONFIG_EXTRA_ENV_SETTINGS \
104 "loadaddr=0x80100000\0" \
105 "kernel_addr=0x100000\0" \
106 "fdt_high=0xffffffffffffffff\0" \
107 "initrd_high=0xffffffffffffffff\0" \
108 "kernel_start=0x1000000\0" \
109 "kernel_load=0xa0000000\0" \
110 "kernel_size=0x2800000\0" \
112 #undef CONFIG_BOOTCOMMAND
113 #define CONFIG_BOOTCOMMAND "pfe stop; sf probe 0:0; sf read $kernel_load "\
114 "$kernel_start $kernel_size && "\
117 /* Monitor Command Prompt */
118 #define CONFIG_SYS_CBSIZE 512 /* Console I/O Buffer Size */
119 #define CONFIG_SYS_MAXARGS 64 /* max command args */
121 #define CONFIG_SYS_BOOTM_LEN (64 << 20) /* Increase max gunzip size */
123 #include <asm/arch/soc.h>
125 #endif /* __LS1012A_COMMON_H */